Hydrolevel 5822 550 Low Water Cutoff Part No. 45-550 Probe Included

PROBE (3/4" NPT 2-7/8" INSIDE DIMEN

Hydrolevel 5822 Part No. 045-550 low water cutoff is a level switch designed for use with many pump manufacturers requiring low water cutoffs that automatically shut off the pump when the reservoir level drops below a pre-set point so that the pump does not burn out. It is designed to be installed on 1" or larger suction lines or discharge lines of tanks, ponds, or pools. The Hydrolevel 5822 will accept 3/4" NPT with 2-7/8

This automatic low-water cutoff system is capable of monitoring two tanks and automatically shutting off the pump at pre-set water levels. Set up one pump for each tank and be alerted by the alarm, if one tank empties, allowing the other to maintain water level. Includes 4 ft. of 3/4" hose, 5822 probe, 3/4" NPT x 6" threaded post & plastic stand.

This item is just as described by Amazon. There is a $300-$600 range for this same part. I AM ELIMINATING MY WATER BILLS BY USING THIS VERSION OF THE HYDRAULIC PRESSURE SENSOR FOR MY TOILET VOLUME CONTROL AND IS SIMPLE TO MOUNT AND SETUP

The Hydrolevel 5822 controls the flow of water to a reverse osmosis system. It includes 2 meters (HOT and COLD) and 1/4" NPT brass quick connect fittings for easy installation. The unit has internal pressure relief valve that opens at 60 PSI, and has a 20 PSI regulatory relief valve. A built-in low water cutoff relay is factory set at 3 inches. A constantly monitored indicator bar graph provides visual confirmation of water level in the tank

The Hydrolevel 5822 Low Water Cutoff is an easy-to-install water shut off valve for irrigation applications. It can be located anywhere along the water line to protect against freeze damage. For use with 1/2" copper or polyethylene water line tubing for remote locations up to 50 feet. It may also be used with 1/2" polyethylene tubing up to 100 feet up to 100 PSI (pounds per square inch). The built in standpipe provides a location

The Hydrolevel™ 5822 is a narrow, low-volume type water cutoff that is ideal for pool and spa water level control. The Hydrolevel 5822 features a large adjusting knob to make it easy to set the desired water level. It also has a fully adjustable rod depth to accommodate all types of plumbing configurations. The Hydrolevel does not incorporate any moving parts, so freezing is never a problem. Each unit is tested at our facility prior to leaving the factory.

This water shutoff is self-contained and has an on/off reset button. The unique design combines the tank-mounted float with a low-level sensor that uses dual float switches to sense low water conditions from both the bottom (tank) and top (sump) of the tank. The 3/4 in connections allow this device to be used on most conventional indoor and outdoor residential water heating tanks. This combination model can be used with just a hot water heater or it can be installed as