CK-92FV Draft Hood Sys
A CK-92FV Draft Hood System Control Kit is designed to operate the CK-91RFC Duct Fan and the 28MVV DV Draft Inducer, and is used to vent natural gas or liquid propane. The kit includes a 20-foot control wire, two 5-foot extension wires, an external shut-off switch, and one 14-inch fan cable with plug.
The Field Controls CK-92FV Draft Hood System Control Kit is designed for use with the SWG Power Venter and DI Draft Inducers For Controlling Natural Gas or LP Gas Appliances Equipped With a 24 VAC Gas Valve and a 30-millivolt Controlled Spark Module. It includes an Inducer Wiring Harness Assembly, Draft Hood System Control Wiring Harness Assembly, and a Mounting Bracket.
Control Kit for CK-92FV HEAT CONTROLLER For use with natural gas or LP gas appliances equipped with a 24 volt gas valve and a 30 millivolt controlled draft inducer.
CK-92FV control kit includes a Control Module with draft inducer relay, a pair of jacks, 2 leads and a set of instructions. This kit is suitable for use with the SWG Power Venter and DI Draft Inducers for controlling vent fans equipped with a 24 volt gas valve and a 30-millivolt controlled switch.
The CK-92FV Control Kit is a universal control for snap-on venters and draft inducer systems such as the SWG Power Venter and DI Draft Inducer. The control features Piezo ignitor, pilot ignition and shutoff safety switches.
The Field Controls CK-92FV Control Kit is designed to provide field installation of the power venter, thermal limit switch (THS), draft inducer, and verification switch for natural gas and LP gas appliances.
The CK-92FV control kit will work with any of these units as long as it has the factory installed 24 volt valve on the unit.