Johnson Controls A350PS-1 -30/130F SPDT24vPropCtrl -30/130F SPDT24vPropCtrl

-30/130F SPDT24vPropCtrl

This Johnson Controls A350PS-1 -30/130F SPDT24vPropCtrl with a Maximum Amperage of 1.0 AMP is a 245 Degrees Fahrenheit thermally protected Phase Lead Power Controller with a Non-Diagnostic Input.

The A350PS-1 -30/130F SPDT24vPropCtrl is a 24VDC actuator with an built in built in temperature sensor for sensing the temperature of the air being supplied to new or existing 110VAC or 230VAC systems.

Johnson Controls' Portable A350PS-1 -30/130F SPDT24vPropCtrl Outdoor Combination Deep-well Switch and Solenoid Valve with Lockout is a complete control package that can control up to a 120 Amp, 208 volt branch circuit. Ideal for the water pump protection of a chiller, fishing pond pumps, trash compactors, multifloor radiant floor systems, small area heating units , outdoor fountain units and many other applications.

The Johnson Controls A350PS-1 -30/130F SPDT24vPropCtrl is a 3-wire, pressure control solenoid valve installed in a MPU with 120VAC coils. The A350PS-1 series selectable pressure solenoid valves have been designed for switching various liquids and gases in industrial applications when used with low pressure from 0.5 PSI. This unit comes standard with a spring return to valve open.

A350PS-1 -30/130F SPDT24vPropCtrl is the main controller for the A350 Series Power Supply Systems. It remotely controls an auxiliary alternating current (AC) circuit power supply and provides automatic fault detection and shutdown (FD&S). A350PS-1 can control 1, 2, 3, or 4 individually switched 115V circuits with internal lockout feature when configured to control four circuits. Each circuit is totally independent of other circuits in an A350 Power Supply or when controlling multiple standalone controllers in a multi-controller configuration. The A-350 system uses energy efficient switching power supplies for low

The Johnson Controls A350SP-1 30/130F SPDT24vPropCtrl was specifically created for use in a wide range of electric actuators at a low cost. The electronic components made use of in this switch system have the largest variety of features among our switching devices. They have VDE IEC approvals to CE standards, and comply with UL standards for safety, EMI, and emissions as well as encapsulated plastic housing. Their components are highly reliable, appropriate to their intended usage, smaller, lighter, and offer the greatest freedom for layout during assembly compared to those from other manufacturers.

The A350P-SPDT24v is a 24 VDC electric proportional controller for non-contact applications. It regulates the output signal according to a user-adjustable reference input and a feedback input, using a PWM drive circuit. Features include 0.5-32 RPM range, 0.1 resolution, programmable hold feature, adjustable hysteresis/lead angle, differential inputs to prevent cross-contamination, mechanical brake clamp output, and 10mA surge current capability.

The A350PS-1 series is designed for a wide range of HVAC applications, including fancoil heat pumps and reverse cycle split systems. The A350PS-1 series can be connected directly to the ac bus or associated control circuit. When used with a reversing valve pressure from 130°F to -30°F is available for temperature regulation. Both high side and low side solenoid pilot valves are standard within the unit.

The A350 range is a fully proportional speed limiting switch range. The A350PS-1 is a general purpose proportional speed control switch operating from 0-30 VDC nominal output and 0-130 VDC nominal input supplied by a 24 VDC pneumatic supply system.

Controls the speed of an electric motor with DC voltage input, or provides 24V DC power to other devices that require a constant 24VDC source. This Johnson Controls A350-P1 24VDC PWM step down 120/230VAC transformer/rectifier is rated at 15VA, 120 VAC input, 60 Hz, 2.1 Amps output. It has an operating voltage of 0 to 110 VDC.

The Johnson Controls A350PS-1 is a 1 pole, 2 stage, and 3 and 4 wire controls power pack. It has a maximum rated current of 30 Amps and a maximum switching capacity of 130 Amps @ 240/250 VAC. Enclosure Ratings: NEMA 1 - Front panel NEMA 4X - All other parts The A350PS-1 power pack features an over current relay as standard. The A350PS-1 power pack is UL listed Class 1 Division 2 and classified as equipment.

For some applications, a more robust reversing controller needs to be considered. This ruggedly built device is a two-speed application with a continuously variable speed jumper wire. This device's fully potted design eliminates the possibility of any internal corrosion and provides positive protection from dust and moisture.