Honeywell 3261 , Inc. 1/2 x 3/4 Inlet Low Voltage Combination Gas Control, LP Gas.

24V STANDING PILOT NATURAL GAS VALV

This 24V Standing Pilot Natural Gas Valve only works with Honeywell's low voltage control systems. The valve allows you to use standing pilot lights in separate appliances while maintaining the ability to control the flow of gas to each appliance independently.

Honeywell 3261 , Inc. 1/2 x 3/4 Inlet Low Voltage Combination Gas Control, LP Gas, 2V WATTS 240, 30A MAX CURRENT; 24V STANDING PILOT NATURAL GAS VALVE

This real brass standing pilot control is from Honeywell's AVANTI V2 Series. It is a 1/2" inlet Low Voltage Gas Control. It features an adjustable orifice, manual reset low level flame failure switch and a 24V igniter. The ON/OFF lever allows for easy on/off switching for gases with either blue or yellow pilot lights.

A standing pilot is required by the National Fuel Gas Code and most state applicable building codes. The Honeywell 3261, Inc. 1/2 x 3/4 Inlet Electric Combination Pilot works with natural gas (2000 Btu) applications. SimpliSafe Gas Leak Detector

The Honeywell 3261 is a 1/2-Inch x 3/4-Inch Inlet Low Voltage Combination Gas Control that provides an economical solution to control the flow of natural or LP gas. It has a standing pilot with a manual reset safety device and a lockplate for fixed applications. Features include a durable plastic body and label plate, a natural yellow chromate finish, and both IN and OUT connections are stamped into the steel body.

Honeywell 3261, 1/2 x 3/4 in, Low Voltage Combination Gas Control, LP Gas. For use on indoor gas equipment requiring a combination gas control with built-in check valve and standing pilot. Round body design allows unit to be mounted from the top or side. Brass internal parts are suitable for natural or liquefied petroleum (LP) gas.

A 1/2 inch conduit inlet gas control, this unit features an adjustable pilot, a standing pilot control, and an adjustable thermostat to adjust the output flame temperature of one or two burners. This gas control may be used on natural gas or liquefied petroleum gas (propane) where code requirements permit. It provides for automatic reset of pilot and thermostat after power interruption.