HEIL QUAKER / ICP 211087 Heil Quaker Furnace Control Fan Timer

FAN TIMER CONTROL *** nla ***

The Fan Timer Control converts your current Heil furnace from a single-stage, mechanical thermostat-controlled system to a two-stage forced air heating system. The Fan Timer Control can be installed on any existing furnace with an auto switch, an operation switch, and a 1/4"C terminal strip or larger -OR- if the installation is for a new system, the Heil QTK series of furnaces come standard with these components as part of the unit.

THE ICP 211087 IS A SQUARE D FAN TIMER WITH A WHITE LEGEND AND BLACK BASE. THE TIMER IS 9" X 4.5" AND HAS THREE SPEEDS. IT IS USED TO CONTROL THREE-TRUNK FANS ON HEIL 21000 SERIES QUAKER MODELS.

A fully functional fan timer control intended to replace the one that comes with the IC 211087 Heil furnace. It runs independently of the furnace power relay and has three fan settings.

Time your Heil or ICP series burner from a distance. The ICP 211087 fan timer control is compatible with other brands of heating equipment that have a Pressel cable.  This includes the following models, among others:  Part No. 00113 Heil Quaker Intake Manifold with Fan for use w/ IC21105-00126 IC21105-00127 & IC21105-00132 00106 Heil Quaker Panel for use w/ IC21102M-00025 & IC21110C-00010 (720038172) 00112 Heil Quaker Panel

This timer is designed to give the operator complete control of the time of fan operation after the furnace has been run. Preprogrammed with three different fan delay times, (1) 5 min., (2) 8 min., and (3) 10 min., set lever. This unit can be used in series with a conventional T-Stat. A normal application would be for delayed furnace operation, program timer for 5 minutes and then don't have to reset the T-stat but when other demands such as lighting off appliances run the furnace for heat. Can also be used to allow fans to run long enough for oil fired heat

The ICP 211087 Control Fan Timer provides the ability to control a conventional forced air furnace for both heating and cooling. Ideal for smaller homes or locations where localized heating and cooling needs to be controlled independently.

THE TIMER CONTROL BOARD IS USED TO REPLACE THE FOLLOWING PART NUMBERS