SCHLAGE 35056H 35-056 H CONTROL KEY BLANK

35-056 H CONTROL KEY BLANK

How do you keep the good guys out and only let the right person in? By using a control key blank to create or change a master keying system. The 35-056 H control key blank is designed for use on Schlage Control Keyed Cylinders, Control Mortise Cylinders, Deadbolts and Deadlock Latches.

This Schlage control key blank is intended for use with all brass backset mortise locks and deadlocks. This Control Key Number 35-056 H is used on the following exterior entry products: E101, 101C, 101CW, 106CW, 106B, 141W, and 141CW

SCHLAGE brand 35-056H control key. This is a factory cut control key blank. Each key is machined to the fine tolerance that Schlage locks are known for.

SCHLAGE TRIM-LATCH LOCK KEY BLANK - 35-056 H

The Schlage CONTROL Key Blank 35-056H is designed for use with the Schlage Locks listed below.

The Schlage Key Blank for the 35 Series is a control key blank and fits all Schlage 35-Series locks, Schlage A series Deadlocks, and ClIQ(TM) deadbolts.

Control Key blanks fit a Schlage Everest line cylinder. This key blank is only intended as a replacement part for the actual cylinder shown on this product page. This key blank will not operate any other locks or cylinders and is always keyed to the same bitting code.