WHITE-RODGERS 5110 Thermostats Manual Reset Cut-in 200FOut Open on Rise

LIMIT CONTROL MANUAL RESET 200F

25% OFF

The WHITE-RODGERS 5110 Thermostats Manual Reset Cut-in 200FOut Open on Rise control is a limit control. It does not include a hold feature and does not provide for superheat protection. The system's limit control will open if the heating temperature rises above 200°F (93°C).

The White-Rodgers 200F Limit Control (Part No. 5110) is a limit control thermostat designed for use with oil and gas forced-air furnaces, boilers and water heaters where a low limit control is required or desired. The White-Rodgers 200F Limit Control features adjustable setpoint, temperature rise, and manual reset. The thermostat can be programmed for up to four on/off cycles per day. It features a lockable program dial which prevents the program from being changed without a special key.

The WHITE-RODGERS 5110 Thermostats Manual Reset Cut-in 200FOut Open on Rise Limit Control is a Limit Control with manual reset. This product is designed for use with baseboard heating and forced air or radiant heating systems. The limit control is used to prevent excessive temperature rise in the heat exchanger or furnace by limiting the amount of heat delivered, when the air temperature in a zone rises above a predetermined value, causing the blower to stop. If the zone temperature falls below another predetermined value, the blower starts again.

The White-Rodgers 5110 Thermostats Manual Reset Cut-in 200F Out Open on Rise Limit Control is a combination limit control and manual reset device used to control heating or cooling systems. This thermostat is designed for use on boilers, furnaces, and forced air units that use water or electrical heaters.

The manual reset cut-in 200F limit control is a normally closed, internally energized, normally open type of limit control. It functions to open the contacts when the temperature reaches 200°F. The contacts close and energize the device again after they cool to 150°F. This unit has a 1" sweep, black face frame with white dials and is used in residential type gas fired heating equipment.

The WHITE-RODGERS 5110 Thermostats Manual Reset Cut-in 200F Out Open on Rise Limit Control allows the user to manually reset the upper limit at any time during a temperature demand cycle. It is used on boilers and heating systems that operate in a non-automatic or intermittent mode. This thermostat set should be installed as part of an adequate temperature control system.

The White-Rodgers 5110 Thermostat Manual Reset Cut-In 200F Out Open on Rise enjoys the reputation of being a quality make that is appreciated by the customers. The thermostat is a product of an excellent design and helps in enhancing your comfort level. It has been designed with a vision to provide you with the required temperatures. The thermostat is made up of durable components and this has resulted in it being long lasting. It also enables you to enjoy the maximum comfort levels.

The White-Rodgers 5110 thermostat is a Limit control manual reset 200F cut-in. It has a limiter which senses the temperature and automatically turns off if it gets too high, as well as a manual reset button so you can turn it back on without waiting for the cycle to be complete.

The White-Rodgers 5110 Thermostats Manual Reset Cut-in 200F Out Open on Rise Limit Control, is a 1/2-Inch, 1/2-Horsepower, Normally Closed, Limit Control That Functions As A Coil Protector In Unitary Air Conditioning And Heat Pump Systems.