NORDYNE 626422R 626422R L155 LIMIT c L155 LIMIT c

Rollout Limit Switch 155F

The 626422R Limit Switch 155F has a stainless steel body and is used in hazardous locations for this type of application. It is a limit switch application. The input is AC with N.O. contacts. The output is AC with N.C. contacts. There are two screws on the top cover. One length is approximately 1 and the other is approximately 1 .

NORDYNE 626422R Limit Switch 155F Description: Release action snap-switch, acts on Pivot Type Actuator, Pressure Contact, Normally Closed, Plunger Dia. 0.40 In., 2 pole, NC contact type, Wire size (AWG) 16 to 14, Corded/Cabled connection, mounting hole on cover for cord exit or conduit entry and adjustment screws with nut lock

This Limit switch is designed for use with all LIMIT brand of tapered roller bearing conveyor belting. It features center-adjustable stop base and grease fitting.

The L155 Limit switch is commonly used in applications where the door of the dryer or cabinet cannot be equipped with a face mounted switch and bulky external lever or cable assemblies. The L155 Limit switch may be mounted to the frame or supported by a 24-Gauge mounting flange.

The Limit Switch L155 is compact, light duty, spade terminals, and For use with Nordyne 12 volt and 24 volt Fan-Cooled Heat Exchangers. When used with a limit switch initiator, the N155 can be used to start and stop coolant flow in heat exchangers. The N155 Limit Switch features a temperature range of 95-122F (35-50C) and ambient operating temperature range of 23F to 104F (-5C to 40C).

Mounted on spring-tensioned roller assemblies, the 626422R Limit Switch is used to stop or limit motion on continuous-action mechanisms. The switch mount is built in two pieces with a split adjustment ring that allows mounting onto small diameter, large length shafts. The switch can be adjusted to any position of the shaft centerline within the outer edge of the roller assembly by means of a projection on the slide-ring assembly and a locating hole in the switch body.

This product is designed for use in pediatric wheelchair applications. The Limit Switch is free of lead, cadmium, and mercury. It features an easy to clean polycarbonate housing and a 10' silicone cable that can be routed to either the front or rear axle ends of the wheelchair.