SCHNEIDER ELECTRIC 28972 (Barber Colman) AT-1163 WireStatGuard 6.5hx6.62wX3.25d

Wire for Duplex w/wo Sub-base for S

WireStatGuard S Wire for Solid Singles, Duplex w/wo Sub Base (5h, 6.62W, 3.25D) AT-1163 is an almost invisible wireguard enclosure used to preserve the integrity of the wire when installed using mechanical splices or direct buried installations. Self closing doors will fit any size WG6.5 housing. Using interchangeable bases with a 4"Wx4"D" Steel & Plastic sub base this enclosure features a 16 Ga.

The WireStatGuard is a sub-base and wire guard combination designed to house coiled communications or bus wire in conduit, and will fit any bar type junction box (except enclosure) as well as any standard wall opening. Designed for easy installation, the WireStatGuard's snap-in cover makes for fast and easy wiring. Constructed of glass-reinforced composite, it will not corrode or rust and will last many years. The WireStatGuard is UL listed and meets NEC requirements

Designed to mount on the wall, this panel features a design that fits small to medium-sized combination or duplex receptacles. DETAILS: grounded mounting strap for added safety and durability, 2 sturdy wings for fast and easy wire insertion, Quickwire channel accepts Romex® cables with connectors already installed for a make-ready installation. Ideal for residential and commercial applications where duplex receptacles are used.

AT-1163 WireStatGuard,Barber Colman,used for duplex receptacle. Wires cannot be covered up by any obstacles or they must be de-energized when any of the following points are within 5 meters: Overhead high voltage wires (except in valley areas), Ground wires, Overhead noncontact lines or conductors in buildings where combustible materials are stored or used, Overheads lines and conductors in arc-welding pits or where explosion hazards exist

Protect wire up to 3/4 in. Dia, Includes an 8 ft. Cable and a 6-1/2 in. Frame, Holds one wire SPAN:5'' SCHNEIDE KUSTOMMODS Inc.

WireStatGuard - Flush Mount 6.5" x 6.62" x 3.25"

Single output system monitors wire directly in each circuit (6-wire and 4-wire). The two channels in one enclosure are programmed independently.