Belimo FSTF120-S Fire/Smoke 120v S/R On/Off Act Fire/Smoke 120v S/R On/Off Act

Fire/Smoke 120v S/R On/Off Act

The Fire/Smoke 120v S/R On/Off Act allows for monitoring of smoke and fire detectors. Monitors for two (2) circuits with one or two input circuits each. Provides an audible and visual alarm to indicate the alarm status of each circuit. Requires a connection to a 110/120VAC power source and common grounding with the detector (hardwire). The front panel also includes a selectable output to set a detector reset point at 15 seconds or at 30 seconds.

The Fire/Smoke 120v S/R On/Off Act model FSTF120-S is designed to provide automatic control of a fire/smoke alarm throughout the dwelling. The unit will shut off power or gas to the fire/smoke alarm device which will silence nuisance alarms while allowing other devices to continue working. The unit features 120VAC 18A, UL listed, 1 pole - 2 wire - normally closed contacts and 1 pole - 2 wire - normally open contacts.

Belimo FSTF120-S Fire/Smoke 120v S/R On/Off Act

The Belimo FSTF120-S Fire/Smoke 120v S/R On/Off Act is designed for use in residential and commercial applications. This unit is equipped with a delay time of 15 seconds, a current rating of 120/240 volts at 30/15 amps, and includes the fire alarm output port for use with a fire alarm system.

The Belimo FSTF120-S Fire/Smoke 120v S/R On/Off Actuator is designed for commercial and industrial applications that utilize fire and occupancy control systems.

Protect against fire and smoke damage with the Belimo FSTF120-S Fire/Smoke 120v S/R On/Off Act . Ideal for use in sump, sumps, wells, holding tanks, crawl spaces and more, this sensor switch is designed to meet the requirements of UL 489. This 120v on/off act controller provides a level of control to detached structures such as barns equipped with UL listed detectors.

The 120 volt S/R On/Off Act FDN616F module, provides a method for controlling a fire or smoke actuation device (such as a dry-pipe sprinkler system) at the beginning of an alarm signal and de-energizing all circuits at the end of an alarm signal. The FDN616F is compatible with hardwired or demand type systems. Additionally, this product has been designed to interface with the Belimo FDN816 Event Module in a multi-module control panel environment.