Honeywell 10539 , Inc. Minipeeper Ultraviolet Flame Detector, NEMA 3 and NEMA 4, 12 ft leads

MINIPEEPER UV DECT.-40F 12'LDS

The Minipeeper UV DECT accessory allows the UV detector to be used for other hazards that can be detected by the 9-volt flame or smoke alarms, such as carbon monoxide and natural gas. It has 12ft wires and requires a 9-volt battery.

The Minipeeper™ UV Flame Detector Series-40F Duct Mount Detector is a fixed-level, non-contact detector designed for use in residential and commercial forced air heating equipment. The detector provides the user with an audible and visual alarm by monitoring R-410A Piping Systems.

The MINIPEEPER UV-DECT Dimensional Flame Detector is a compact flame detector for rough-in surveying and dimensioning applications where Duct Smoke or other obscuring gas, vapor, mist, fog, or dust exists. The MINIPEEPER UV-DECT Dimensional Flame Detector evaluates two independent 32mm (1.25") NPT optical ports for the presence of hazardous gases and/or flames from pilot lights.

The Minipeeper UV flame detector with 12-foot leads is designed for use as a loop detector around the opening of an air curtain. When used as a flame detector, it can detect flaming fires and is useful for early detection of smoldering fires. It requires less than 2 seconds to detect flames in excess of 25 inches above the floor or surfaces from 3 feet away.

The Minipeeper UV Flame Detector with UV-40 flame sensor is designed for use in natural gas, propane and oil applications. The UV Flame Detector with UV-40 is constructed of stainless steel, glass, plus a flame sensor that provides no false negatives and no false positives. Use your UV Flame Detector with UV-40 to monitor proper installation and maintenance of hot gas systems.

The Minipeeper UV Flame Detector provides a low cost UV detection solution that is easy to install, calibrate, and maintain. The Minipeeper offers an economical alternative to existing flame detectors that rely on ionization technology. No tools are required for installation.

Simply plug it into an electrical outlet near the furnace and the Minipeeper UV will do the rest. When it detects a flame, it immediately sounds a factory-supplied alarm. Then it resets itself to wait for the next fire.