Honeywell 279703 C7250A1001 JADE TEMP.SENSOR(20K NTC) JADE TEMP.SENSOR(20K NTC)

ELECTRONIC 20K TEMP SENSOR

The Honeywell JPS20K is a specially designed NTC Thermistor (thermal resistor) for use with the C7250 and other temperature monitoring applications. The JPS20K is utilized within the C7250 as a temperature sensor to monitor and control temperatures precisely and reliably on heat transfer equipment. This part is essential to continue proper functioning of the C7250A1 with the latest firmware.

The JADE TEMP.SENSOR is a versatile electronic single-output, solid-state temperature sensor. The JADE has four factory-programmed sensitivity settings (with preheating) ranging from 19.5 to 100 degrees C (approximately 67°F to 212°F) with an output voltage of 0 to 5 VDC in steps of 1 mV/degC. Each of the JADEs four programs are selected by momentarily placing the internal switch in its shorted position

The 20K? NTC thermistor (NTC = negative temperature coefficient) is designed to measure and control the temperature separately for each zone. The active elements can be used to protect heating coils from overheating. The sensing element above a certain temperature and then gradually decrease its resistance as the temperature goes down with the negative current flowing through it. This large thermistor can be used as a high-temperature device or as an on-off device because of its wide voltage-current range from 0

The Honeywell JADE Series Sensors offer the Gold Standard in Temperature Measurement Technology. The JADE sensor can be used in areas where extended temperature sensing is needed (i.e. Blood Alcohol, Elevator Pitches, Superheated Steam, Hot Cylinder Heads, and HVAC).

The Honeywell® JADE™ TEMP.SENSOR is a two-wire type with its flat sensor element mounting directly onto the surface where the temperature measurement is desired, such as a printed circuit board. This surface mounted probe eliminates any tubing between the device being measured and the sensor to ensure that thermal gradients do not affect accuracy. The JADE TEMP.SENSOR has an operating range of -40°C to 250°C and has an output of 0V to 3

Easy to read, precise and durable, this NTC (Negative Temperature Coefficient Resistor) type thermistor can be used for temperature sensing on a wide range of applications.

** REPLACES FOLLOWING FILTERS** 49RX009 ** REPLACICES ALL OF THE ABOVE FILTERS WHEN USED WITH ?? ?? 49RX010 PRIMARY HEPA CARTIDGE & REMOVEABLE SEDIMENT PRE-FILTER **REMOVES** 99.97% PARTICLES @ .3 MICRON AND GREATER IN DIAMETER 6" X 3/4"