OTC OTC-6602 CHRYSLER PRE LOAD WRENCH.

Differential Bearing Preload Wrench

34" (34

Weighing only 10

It is designed to tighten the axle housing to the differential housing

The OTC-6602 Differential Bearing Preload Wrench is designed for preloading the OEM differential bearings

The OTC-6602 CHRYSLER PRE LOAD WRENCH is constructed of forged alloy steel for strength and durability

-32 in

OTC-6602: Differential Bearing Preload Wrench

OTC OTC-6602 CHRYSLER PRE LOAD WRENCH is a differential bearing preload wrench

Loosening this nut will increase the preload on the bearings

It is used to set the preload of the differential bearings to prevent over and under torquing

The Chrysler OTC 6602 differential bearing preload wrench is a specialty tool designed to ensure that the differential bearings are set properly when installing new axle assemblies

preload sleeves

The OTC differential bearing preload wrench is designed for many late model Chrysler vehicles

It’s made of heat-treated alloy steel and can be used on 5/8 in

This tool is used to preload the differential bearings of 2005 and later Chrysler vehicles

This is the ideal preload tool for applying settings or removing bearings in differentials and axle housings

Learn More About OTC Differential Bearing Preload Wrench

The main body of the tool has a 1

The differential bearing preload nut is located on the differential side of the pinion flange

This is a MUST DO procedure when installing new axle shafts, especially if the vehicle has not been aligned in a very long time or has excessive play in steering wheel at all angles of steering

1mm) inside diameter to accommodate both bearings and a 0

OTC’s OTC-6602 CHRYSLER PRE LOAD WRENCH is a differential bearing preload wrench

It allows for increased bearing accuracy during installation by means of an adjustable guide that helps control the preload on the bearings

8 ounces, this advanced wrench features a 4-way position handle for better access to a vehicle’s differential and a high strength, stainless steel construction

Get the job done with this OTC Differential Bearing Preload Wrench, which has a 4-in-1 design that tightens preload sleeve nuts on ring & pinion gears, removes differential gears and axle bearings, and installs and removes differential gear seal snap rings

This 1-piece, low-cost tool has a hardened, ground and polished tapered shaft with a knurled end for positive, slip-proof engagement of the bearing cone

It is designed to fit the most popular of the serviceable differential bearings