Johnson Controls C450CBN-4 Control Module W/SPDT Output

Control Module W/SPDT Output

This Johnson Controls Control Module W/SPDT Output C450CBN-4 comes equipped with an N.O. (Normally Open) switching device used to interlock 2 circuits to prevent simultaneous activation of other control circuits. The Control Module W/SPDT Output C450CBN-4 is designed to control heating, cooling, or initial function start-up components.

This Johnson Controls C450CBN-4 Control Module W/SPDT Output is used but in excellent condition.

Just because this unit doesn't have a new face, that doesn't mean it isn't easy to use. In fact, the C450 Cbn-4 Control Module W/SPDT Output is a great addition for your facility.

The C450CBN-4 control module w/SPDT output from Johnson Controls Inc. is a suitable replacement control module for use with the following systems: RWN steel garage door, all steel residential garage door, and most chain . It has a current rating of 83 Amps and a 240-Volt AC output.

The C450CBN-4 is a control module with an SPDT output. It allows for on/off or momentary operation of an existing switch or device.

The C450CBN-4 is a control module with 4 SPDT outputs. This Labeled control module is UL/CSA listed per UL982. Resists shock, dust, moisture and vibrations.

The C450CBN-4 Occupancy sensing Combination Heat and Cool Control Module with SPDT Output is a single printed circuit board with capacitors and resistors for transforming a Normally Open (NO) or Normally Closed (NC) water Valve. The voltage required to energize the SPDT Output is 120 Vac. The control module provides an output in response to the input from the male grip of the Float Switch. The SPDT output will be energized when either or both connected Heating and Cooling stages are calling for heat or cool respectively.

The Johnson Controls C450CBN-4 control module is a 12 Volt DC/AC series wound, solid state relay with SPDT output. The SPDT output can be connected to a solenoid valve, motor starter circuit or any other device that uses a SPDT relay output. This product is manufactured in United States.

This is a 2/4 Digit 0-10V DC meter display. The model number for this meter is the C450CBN-4, where the 'C' represents this meter is a 'control module', while the 450 stands for specific electrical ratings, and the 'B' and 'N' represent where this specific product was manufactured. The last three digits of the model number represent the end use order code. Please see attached document for full description.

Think of the C450 Control Module Series as a centralized computer that can be programmed to control single or multi-function equipment in your home. Control modules come with an eight-zone expansion card to accommodate up to three thermostats, one humidity sensor, and two hardwired accessories. Control Modules can also hold up to 12 build-in or remote wireless security keyfobs.

The Johnson Controls C450CBN-4 module is designed specifically to control the current in 480V applications. It's manufacturer rated current is 8.7 amps at 277/480 volts, with a duty cycle of 50/60 Hz.-25 C to 50 C, with a tolerance of +/-5%. The Johnson Controls module has direct terminal (3) connection.

Johnson Controls C450CBN-4 Johnson Controls 4 Channel Surface Mounting Module, No Battery Included, Parallel Output, For Installation & Replacement Only (not for field wiring)