EATON C320KGS32 Cutler Hammer- 1 N/O 1 N/C Auxiliary

1 N/O 1 N/C Auxiliary

Our C320KGS32 is a 1 N/O 1 N/C Auxiliary Contact for use with Cutler-Hammer Line over Load Relays in HVAC, Lighting and general industrial applications. Our C320 series auxiliary contact has a current rating of 32 amps 480 VAC and match type suffixes R or S. It has an interrupting capacity of 32 amps at 480 VAC. This auxiliary contact features stainless steel screw construction, silver cadmium oxide contacts, trip free mechanical latching, and an extended temperature range of -22 to 100 degrees Celsius.

Eaton C320KGS32 Cutler Hammer- 1 N/O 1 N/C Auxiliary contact is a 2 Pole, 3 Wire, 120/240 VAC, 60Hz, 10A NC, 10A NO with snap-in bushing. It provides an auxiliary circuit to drive demand loads up to 10 amps with pilot lighting. It is ideal for starting small motors and lighting in industrial and commercial control applications.

The Cutler-Hammer C320KGS32 is a DIN rail mountable 3 pole 20 Amp rated auxiliary contactor. The cutler-hammer C320KGS32 contactor has a current rating of 20 Amps @120 VAC, starting current of 80 Amps and features one normal power contact and one normally closed auxiliary contact. With an operating voltage of 240V, this contactor utilizes the N/O function.

June 12, 2012 - The C320KGS32 is equipped with a double pole, normally open (N/O) circuit breaker and a double pole, normally closed (N/C) circuit breaker to provide protection for loads up to 32 amps. It is designed to meet the need for auxiliary protection on branch circuits only.

The C320KGS32 (2R) Auxiliary Switch is a standard single pole change over switch rated at 32A-120/277VAC maximum, AC or DC. It features a brown thermoset enclosure with silkscreened legend, 0 to 125 ampere rating, moisture resistant terminals, and 2 auxiliary contacts on the bottom.

The Eaton C320KGS32/14 Cutler-Hammer single pole single throw auxiliary contact, opens on Normally Open (NO) when system voltage is applied across the contacts. When either circuit on the auxiliary contact receives a 24 V AC signal it will close on Normally Closed (NC). This 3 position auxiliary contact can be used in many different applications.

Auxiliary disconnect switches can help prevent electric failure in buildings by providing a circuit breaker to trips power from the electrical source to connected equipment. These devices are typically used to isolate various circuits onsite that may be connected to a generator service. This type of switch is also referred to as a manual switch, since they are manually operated by means of an external lever handle or push button(s).