Danfoss 117U6013 COMPRESSOR STARTING RELAY COMPRESSOR STARTING RELAY

COMPRESSOR STARTING RELAY

The Danfoss 117U6013 is a 12 V DC, 50 A, relay contact changeover unit with contacts SPDT that change over when 120 V AC is applied. The 117U6013 works with COMPRESSOR STARTING RELAYS. It is suitable for outdoor use.

The Danfoss 117U6013 is a compressor starting relay used with Danfoss/Emerson compressors to prevent compressor startup until the evaporator temperature is low enough for safe operation. The Danfoss 117U6013 Compressor Starting Relay is a 24 Volt DC single pole double throw relay

The Danfoss 117U6013 compressor starting relay enables the compressor to start and operate automatically. It can be used when heating water and for refrigeration systems that use natural gas as a fuel.

The Danfoss 117U6013 Compressor Starting Relay is designed for use with reciprocating compressors, and operates on an external 24-60V DC supply (via the COMPR1 connector of the compressor). It comes in a 40mm housing

This relay has been designed as a universal compressor and motor starter relay for refrigeration and air conditioning systems. It is mainly intended for economisers, where the temperature difference between the outdoor airflow and total load target temperature is at least 3...

STARTING RELAY Mfr. Part No.: 117U6013

In applications where the start of the refrigeration circuit is energized at power-on, a controller may be used to energize the start relay from the PLC. When that start signal is removed, the compressor will not start. The 115VAC coil voltage is 24-28VDC with a contact resistance of <0.2 .