EATON 9-3285-1 Cutler Hammer- 120v COIL

120v COIL

The 120V COIL is designed for use on specific special service load center models only. (Consult the nameplate of the load center to determine if this HVCOIL is correct for your application). The 120V COILS are UL listed for use as a secondary circuit breaker in non-fusible non-combustible locations. For vehicle applications, consult vehicle manufacturer's wiring diagrams to determine correct fuse and circuit breaker sizes for all circuits.

Eaton Cutler Hammer- 9-3285-1 120v Coil is a fully molded, single phase, low voltage soft starter capable of operating motors up to 1/2 HP. This unit can handle temperatures down to 0 degrees F and has been designed for both indoor and outdoor use. It is used as part of a motor protection system for systems that have no hard wiring available for installation.

This is the 10M 120/208V Coil. This product is fully interchangeable with all Cutler-Hammer 9M and 3M brand fuses.

Prevent electrical safety problems by stocking up on high-quality replacement electrical parts. This 9-3285-1 COIL from Eaton is designed to fit Cutler Hammer, and comes in an enduring galvanized steel housing with epoxy finish, providing maximum protection against corrosion and rust.

This Cutler-Hammer coil is an energy-efficient replacement for many standard magnetic low power transformers such as those typically found in drop lamps, nightlights, and small appliances. The high quality core manufactured by Cutler-Hammer Corporation features a copper magnet wire with 120/230 rating.

The Delta C430 Series Cutler-Hammer Plug-In type air conditioner coil is designed to accept air from a supply register or duct system, cool and dehumidify it, and discharge it into a conditioned space. The coil is suitable for mounting in the return air plenum over an air handler containing the evaporator coils. It may also be installed as a separate component when installation of a separate plenum or unit is impractical or cost prohibitive.

This is a genuine replacement part from the manufacturer.