Fenwal 01-018002-000 NEW 120/240V-AC 10A AMP THERMOSWITCH CONTROL SWITCH D512723

Thermo Switch 100-600F

Long life contact closure for use on 120V and 240V devices; voltage application: 120/240 VAC; amps: 10 AMP. Contact rating at 250 mA is 50 ohms. Thermo Switch is rated 110 - 600F (44 - 316 C).

The Fenwal Model 01-018002-000 NEW 120/240V-AC 10 Amp Thermo switch # D512723 is for use with heat lamps, pool heaters, and infrared heaters for poultry brooding. The control has a temperature selection from 100 to 600F. This thermostat will not work with electronic transformers.

The NEW Thermo Switch temperature controlled switches have a broad range of applications. These switches are available with an RTD (Resistance Temperature Device) probe for control of steam, liquid or gas temperatures where the surrounding air temperature may also affect the temperature of the fluid. The RTD probe provides a simple means to compensate for three-way valves and/or constant pressure differentials which have no effect on temperature. These new switches can be utilized as a single point high limit switch in combination with the Thermo Switch Safety Barriers (301580-00) or as an additional switch on a dual pressure system.

The Thermo Switch is a ON-OFF switch designed to be used in 120/240V circuits. This 'push to reset' firing switch is constructed with a stainless steel enclosure and contains a special temperature sensor that senses temperature above the range of normal operation. The switch is connected to the load plug and turns it off automatically if the temperature rises above 100°C (212°F). When the temperature drops below 100°C, heat starts flowing again and the original cycle is repeated.

The Thermo Switch control from Fenwal is a thermal safety sensor switch that is used to monitor temperature in the process control of steam boilers, hot water heaters and furnaces.

The Fenwal 01-018002-000 Thermo Switch is designed to control the temperature of heating or cooling systems. It is 120/240VAC and 10 Amp rated with a maximum current of 8.5 Amp. The working voltage is 125/250VAC at 2 Amp. This thermostat is designed for new construction commercial HVAC equipment but may be used on other heating and cooling systems as needed.

The Fenwal Thermostat Control Switch allows precision control of your heat swarf. This is 100 AC Amp fusible switch with thermocouple protection, a temperature range of 100-600°F (38-315°C) and a 400 ohm NTC thermistor bulb. It has heavy duty terminal connections and features multiple settings that can accommodate 120 and 240 volts.