Fireye MEP101 Programmer, Relight function, allow flame signal d -

"MICRO M PROGRAMMER

Program a main metering device (MMD) to provide precise control of the gas flow to any fire area, with the ability to individually program separate gas supply lines. The "MODEL MEP101" MICRO M PROGRAMMER is specifically designed for use with double acting metering devices (MDE). The relight function allows flame signal durations of up to 6 seconds for those situations where ignition is not continuous.

Turns a 2-1/2 inch valve (M) into a Pilot (P) for the latching or relighting of a pilot. The M PROGRAMMER can clip onto the regulator inlet of a standard MICRO M, MICRO G, MICRO T Series Regulator and direct all gas flow to the sprinkler's pilot valve.

The Micro M programmer is the most advanced control panel on the market. With programmable flame signals and relight buttons, you can protect valuable equipment by extinguishing and relighting it automatically, automatically notify an operator of a problem, trigger a remote warning system in the event of a fire, or simply relax knowing your system always has someone at the controls.

The Micro M programmer is a microprocessor-based device designed for use with the Fireye MEP101 and MEP102 gas valve monitors. The Micro M consists of two identical 4-digit LED display modules, each with its own programming keypad and LED display. Each module operates independently to provide unique functionality that is selectable by a programmed mode switch.

The Fireye MEP 101 programmer is designed with .25, .5, 1.0 and 2.0 second reset selections. In addition, the relight function allows a flame signal detector to complete an alarm reset then turn off power to the panel if it goes out again before detection has occurred. This unit has a built in feature that allows for push-on terminal block screw terminals. It includes a "standard" input terminal strip with screws holes large enough for the lugs on most connectors, an easy to read LCD display which can be dimmed and programmed, suitable for harsh environment.

The MEP101 Programmer allows the user to select the desired ignition timing(s)

The Fireye MEP101 Relay Programmer allows the installer to rapidly program a relay device via a wired signal from any panel that does not have modbus capability. The programmer can also be used to add relays in branch mode or to test for open circuits. This unit can also be used as an add-on to any existing module or panel that does not already contain a programmer.