FLAME SENSOR 90 DEGREE 1195448 SOUTHBEND

FLAME SENSOR 90 DEGREE

The FLAME SENSOR 90 DEGREE 1195448 is used to monitor the infrared burner flame in gas grills. It is designed for use with a South Bend gas grill model listed below. Used with a 115-Volt/60-Hz surface burner, this transmitter has a sensing range of 6 inches to 11 inches (15.2 cm to 27.9 cm) from the face of the flare tip and is adjustable. The transmitter has a self-gelling process, reducing

Flame sensor 90 degree 1195448, Southbend Flame sensor 90 degree 1195448- FLAME SENSOR 90 DEGREE

Flame sensor. 90 degree bend. For use with CVWV dual stage models. FLAME SENSOR 90 DEGREE 1195448 SOUTHBEND Manufacturer: Trio/South Bend

Flame Sensor 90 degrees is designed to fit within the burner base of two, three and four burner stoves with or without electronic ignition. Flame Sensor has a patented design that can replace the standard flame rod with little or no adjustment, eliminating the need for backup safety controls. The flame sensor requires no set up and no calibration. Flame Sensor will detect a flame (flame detection) even before the burner control valve opens (flow detection). It also has a temperature probe that monitors the protective heat exchanger.

Flame Sensor 90°. The Flame Sensor (90°) is a single piece, stainless steel, welded version of the flame sensor manufactured in South Bend, Indiana. This product will include a stainless steel assembly consisting of three pieces: upper, lower and optional mounting plate. Springs, magnets, and/or clips are not furnished with the flame sensor.

Replacement Flame Sensor that lifts when the flame is on proportional and specific to the size of your natural gas or propane burner `n` `n` `n` `n` `n` Flame sensor lifts and drops depending on the flame height. This 92-928 flame sensor fits 90 degree applications where the flame hole is at a 90 degree angle from the surface it sits on. This flame sensor will fit Uniflame grills and fits private label South Bend grills , Brink

Flame sensor 90