PITCO F11075 SAFETY THERMOSTATLCH, 5/16 X 3-5/8, 60 for - Part# ()

Hi-Limit Thermostat 450 degree F, Manual reset

The Hi-Limit Thermostat 450 degrees F, manual reset is for chicken fryers.

With an adjustable thermostat and a manual reset mechanism, the F11075 Hi-Limit Thermostat is designed for use with indoor or outdoor equipment that is capable of reaching 450 degrees F or higher. This residential high-limit thermostat features a polycarbonate case, an adjustable wire mesh element, and a snap-on screw cover.

The PITCO Hi-Limit Safety Thermostat is designed for use to prevent overheat in either a standard electric or gas water heater. The Hi-Limit is rated at 450 degrees F and will respond to thermal feedback approximately 220 degrees above set point.

Provides limit control of burner output for high/low ranges for spot heating. This 140°F Hi-Limit thermostat can be reset manually if the stove is left unattended.

The F11075 Hi-Limit safety thermostat has been developed specifically for the poultry and food industries. The F11075 thermostat is designed to limit the temperature of a heating device to 450 degrees F. This unit can be used in conjunction with any type of poultry heater.------------PITCO guarantees all products to be free from defects and agrees to replace defective parts or merchandise of known defects without cost upon notification within the warranty period.

The PITCO F11075 Safety Thermostat 120/240V 5/16 X 3-5/8' is used to regulate the maximum temperature and keep the unit safe from overheating conditions. This thermostat helps to prevent dangerous situations that could cause catastrophic damage to your equipment. This thermostat takes the place of the old hi-limit switch and will protect against potential damage due to overheating.

For exceptional performance and easy installation, the PITCO Safety Thermostat is ideal for industrial applications. Sampling ports feature emergency stop screws that prevent changes in settings during load drops. The unit is ideal for use on heaters, boilers, blowers, pressure vessels, furnaces and combustion chambers.