Home and Improvement

Natural Gas OrificeThe Rheem 62-22175-48 is a natural gas orifice designed for Ruud water heaters. This orifice attaches to the supply line that feeds the water heater and regulates the flow of water in and out. Handling your own repairs is both simple...

.073 #49 Brass OrificePropane Gas Valve Orifice Size: .073"RHEEM 62-22175-49 Ruud .073 RHEEM 62-22175-49 -Ruud .073 The RHEEM 62-22175-49 orifice fits Ruud boilers with the model number of: RCGB-36GA, RCGB-40GA, and RCGB-50GA. This orifice has an outside...

#51 Brass Orifice (.0670)For replacement orifice for Rheem RTE series water heater igniters.Measure the orifice diameter of your burner if you looking for a replacementThe Rheem Orifice is the smallest orifice that an airflow meter can pass through. The...

LP Gas Burner Orifice #54This is a Rheem OEM part. LP Gas Burner OrificeReplace your RHEEM, RUUD or FOSTER LP Gas Burner OrificeThe Rheem 54 orifice burner is a replacement part for Rheem gas furnaces. This Rheem orifice replaces the original orifce in...

LP BURNER ORIFICE

LP OrificeThe line pressure regulator, or LP orifice, is the largest of the gas valves on your appliance. It measures the amount of gas coming into your appliance from the service line, allowing for an even flow throughout all of your burners. Rheem...

Ignitor - Hot Surface Ignition (HSIThis Ignitor is Hot Surface Ignition (HSI) Kit for Rheem Gas, Electric and Condensing furnaces with pilot ignition. This is a genuine Rheem part for these models, 62-22868-9, 101CGEFI-OA, 101CGI8, 201EGII-OA.The RHEEM...

24V DSI ModuleThis part is a 24V DSI Module. On these parts there is no decimal point on the part number. The part number will be made up of only 2 or 3 digits.When you have a Ruud heat pump, match it with a reliable and cost-effective 24 V DSI (Direct...

DSI IgnitorThe DSI Ignitor is a gas igniter made to work specifically with Rheem's modelsThe DSI Ignitor is a low cost, high demand replacement part used for the ignition of gas water heaters.The DSI Ignitor comes with a reliable, sturdy galvanized metal...

Non-Integrated Flame Sense RetrofitRheem offers a variety of gas and electric combination systems. The Rheem 62-24044-7 Non-Integrated Flame Sense Retrofit allows for the non -integrated installation of a Flame Sense ignition system in Rheem gas furnace...

CONTROL INTERFACE MODULEThis brand new Control Interface Module from Rheem was built to replace part number 62-24102-02 /Protech - Wiring Board - Interf - /Ruud/Protech.A control interface module is used with intercommunication wiring. This module...

Control Board KitThe Control Board Kit by RUUD is compatible with 82-Series gas, hot water boilers. The Control Board Kit is designed for the Rheem 62-24133-82 capacity boiler. It can be used in place of a defective or problem board in the system,...

Integrated Furnace ControlRheem's Integrated Furnace Control systems are available in a variety of configurations to meet the needs of your home comfort system. Built to handle multiple diagnostic functions, including replacement weatherization devices,...

Blower Control BoardThe Blower Control Board is designed to fit a variety of Ruud furnace and air conditioner models. This board has a filter attached to it. The filter helps capture most common pollutants found within the exhaust air stream. When the...

Horizontal Drain PanHorizontal Drain Pan, for Modular Series.The Horizontal Drain Pan makes sure all the water you've drained away from your hot tub gets directed back into the tub. It easily bolts onto your existing drain cover.Horizontal drain pan is...