Honda 75150-VE1-R00 Honda Disk, Driven

DISK, DRIVEN

The Honda 75150-VE1-R00 disk, driven is a genuine OEM part. The P/N (Part Number) of the Honda 75150-VE1-R00 disk, driven is 75150-VE1-R00 from Honda , It is used in the following models: HONDA GX340; HONDA GX390;.

The driven disk brake has a solid disk on the wheel side of the pulley and a sliding caliper on the opposite end. The caliper is attached to a support bracket that's held in place by a spring in front of the axle. The spring allows for regreasing of the caliper and lets one side of the bracket move with respect to the axle as the wheel turns. On some designs, rebound springs may be added for mounting at one or both ends of the brake assembly.

The 75150-VE1-R00 Honda receiver drive disk is for use with several Honda models and various attachments, including the HA75160, HA75161, and HA75201.

The HMX500HT features a single line hydraulic motor that runs on standard pressure (as low as 8 psi) to power the disc, driven mower. The constant flow pump provides you with the same torque at any speed, guaranteeing precise control and greater efficiency in any application.

The Drive Assembly has two simple purpose. To engage the clutch on a snow thrower or lawn tractor, and to actuate the brake (parking) pawl on those models equipped with a parking brake. This is done by means of a hydraulic pump which is driven by the engine crank shaft.

Drum pump that is driven by the crank shaft.

A drive belt which drives the rear wheel assembly. The belt that goes around the rear wheel pulley.