Honeywell 301-C-DLC Controller with datalogger, ABS polycarbonate encl

"Gas Det.Cntlr

The analog gas detector controller 301-C-DLC is a programmable, portable monitoring and alarming device for indoor air quality. The powerful and compact device can be connected directly to the sensors of our AMK series gas and water level detectors, as well as any other sensors that measure concentrations up to 40.000 ppm. This allows you to use the 301-C-DLC in a variety of applications where you need a reliable sensor connected to a small form factor, digital gas indicator."

Designed for use with gas and steam systems, the Honeywell 301-C-DLC controller offers additional benefits including a variety of configurable options and an optional datalogger.

The Honeywell 301-C Digital Controller is a direct Fire Marshall approved controller with remote datalogger. The 301 is designed to control a natural gas furnace or air conditioner for residential, commercial, and light industrial applications. The 301 has a dual slope programming feature which allows the setpoint to change at multiple set time intervals during the 24 hour period. This leads to energy savings by turning the system on/off only when needed. The controller also has logic functions that will close dampers in stages when temperature rise above/below limits programmed.

The Honeywell 301-C-DLC controller is a three zone single stage gas controller available in a stainless steel case. It can control up to three flex pipe evaporative coolers and has two internal multiplexor channels for connection of additional accessories. Our controllers also come with a built in datalogger for monitoring applications. If you require logging or gas disinfection you can upgrade the controller.

For Gas Suppression Systems Only

The Honeywell 301-C-DLC controller incorporates a 24 Volt detector for use in 3-wire background suppression systems. It is designed for use with propane, natural gas, liquefied petroleum gases (LPG) and mixtures of hydrocarbon gases (H/C <1%). For applications where background levels of H/C are above 1% a single sensor controller (301-A2) must be used.

The Honeywell Datalogger 301-C-DLC Controller offers two separate and simultaneous inputs, fully configurable alarm and shutdown logic with alternate output, and an optional LCD display. The 301C-DLC offers a low residual gas monitoring (LGRM) function that can be used to monitor high level of natural gas present after furnace shutdown. Programmable alarm limits for O2/CO/H2S/CO2 are stored in memory when the instrument is powered off; the signals from the other sensors are not stored while the power is off in order to protect them from false triggering. The datalog