Honeywell 395466 Envelope Assembly with a flame current test kit - Black and White - /U -1

SV9500 TEST LEAD KIT

The SV9500 TEST LEAD KIT is used to test an SV9500 series Voice Messaging System with a Flame-Current detector that is not part of the system (supplied by the customer) that is to be tested.

The 395466 Flame Current Test Lead Kit helps test 95VAC or 125VAC installations connected to the SV9500, by allowing for measurement of electrical current without disruption to the system. The Flame Proof test leads measure up to 10 amps from a distance of 21 in (53 cm).

Our flame detector test lead kit uses the SV-9500 chassis. The SV-9500 has a built-in reset circuit and an audible alarm on the test unit and a dual range knob for selecting the test modes. It can detect high (flame) or low (glow) level of TTG and IGT, and is USCG approved.

The SV9500 kit provides the capability to test or characterize the response of the SV8100 Series  and SV9400 Series gas and air ionization detectors. The kit includes a selection of test leads and accessories to meet your specific testing needs.

This Flame and Arc current test lead kit gives you the control you need to test all Honeywell SV9500 Digital Display fire and arc detectors. It's perfect for testing individual detectors to verify proper operation prior to installation or troubleshooting detectors that have been installed for a while.

The SV9500/U flame current tester kit is intended for use with the SV9500T series of testing heads.

With the 395466 combination kit, the SV9500 leads are pre-wired and have a detachable pigtail.