Honeywell TLM1110R1000 RedLINK Enabled Electrical Heat Equipment Interface Module - /U -c2

WirelessLineV EquipInterface

The RedLINK TLM1110R1000 can be used with the WirelessLineV Cordless Telephone Transceiver (TLM1100) to provide an interface that allows control of heating equipment between common radio protocols and RS-232 serial functionality. This empowers the ability to control such devices as heat pumps, pool pumps, water heaters and air conditioners over your standard telephone line.

The Heat Equipment Interface Module (HEIM) is a two-wire transmit/receive radio frequency (RF) interface device designed to provide up to 8 programmable thermostat functions without the need for hard wired connections. The HEIM connects to the HeatLineV or WirelessLineV equipment wiring using standard 0.25" conduit, clamp terminals or six inch twisted pair

The RedLINK™ Enabled EquipInterface Solution provides a simple and innovative method of communicating between the TL92X Communicator and the RS-232C serial devices attached to it. Whether 1 or 100 sensors, this networked solution allows multiple devices to communicate via the RedLINK wireless infrastructure with minimal set up time and effort. Save time, money and increase your safety through ease of installation.

TLM1110R1000 The ideal solution for designers, contractors & building owners needing a low-cost, wireless HVAC interface. The TLM1110R1000 is Honeywell's first EquipInterface control to support the new RedLINK Wireless Protocol. It provides wireless communication between 2-, 3-, 4-, or 5-wire devices and communicates directly with your HVAC system controllers.

Add a compatible thermostat control or gateway to your Honeywell RedLINK Solution and take control of your home comfort from virtually anywhere using your mobile device. The EquipInterfaceTM is designed as a gateway for your existing in-wall thermostat. It communicates through your WiFi Router with the RedLINK central controller that's located in your home.

Honeywell's EquipInterface series of wireless devices enables new levels of simplicity and efficiency in connecting your electronic furnace, boiler or pool pump to a remote Honeywell thermostat.

The Honeywell TLM1110R1000 is a RedLINK enabled source that allows you to connect your equipment via wired or wireless (Wi-Fi) technology using the Internet. Use an internet connection whether onsite, at home, or on the road. The EquipInterface has a built-in web server with internet connection and it enables remote monitoring of temperatures to optimize control. It is compatible with the Honeywell 6000 and RedLINK 7000 series thermostats.