Honeywell VBN3AFPA0000 1/2NPT 3W 2.4Cv BRS STD PRFL

1/2NPT 3W 2.4Cv BRS STD PRFL

Get rid of the hassle of having to be close to a wall, or sitting next to stacks of batteries while you work. With the Honeywell VBN3AFPA0000 1/2NPT 3W 2.4Cv BRS STD PRFL, you can put it on any surface, even on their side so you do not have to worry about them catching on something and causing a problem. They are also able to fit where space might be a problem since you can get 6 packs in one box and they do not take up as much space as some other similar options.

The Honeywell VBN3AFPA0000 1/2NPT 3W 2.4Cv BRS standard pressure relief valve is designed for installation on intermediate and small commercial air conditioning and heating systems. The valve is used to prevent over-pressuring the system.

Designed to work easily with rental and dual-fuel systems, the UPVC 3W 2.4Cv BRS Steam Trap has a standard pressure rating of 125 psi (8.6 bar) at 270°F (132°C). The heat transfer capability of the trap depends on pressure, temperature, flow rate, and fluid properties; consult your local Honeywell or Emerson Process Management sales representative for assistance in calculating the proper system performance.

The Honeywell 1/2NPT (black and red) solenoid valve is designed to control natural gas to a burner or appliance. This valve utilizes a BRS (ball relief seat) and is pneumatically operated. The BRS is an atmospheric seal in which the ball opens into the seat when energized, allowing the flow of gas. This series has a flow area of 2.4 Cv at a system pressure as high as 28 inches w.c..

With room for up to two 16? plates, the BRS-3000XL can handle larger vessels and offer greater savings. The 1/2NPT version is integrated with the Honeywell electronically controlled proportional (ECP) solenoid valve that performs like an on/off switch, as well as signal start and stop. This model comes standard with an integrated 20 psig burst disc inlet that allows use of a disposable, pre-pierced cartridge. A compatible tank is required.

The BRS-335 Series Burner High Lift is specifically designed for use with 18 inch x 26 inch (457 mm x 660 mm) grills that have a rear mounted drip tray. The kit features the unique BRS-335 high lift burner head. The large 2.4 Cv/watts NFPA approved burner provides up to 473,000 BTU'S of heat, perfect for grilling hot dogs at a neighborhood barbecue or cooking 4 large steaks. The stunning radius front plate and classic knurl edge pattern add to the elegance of this high lift kit

The BRS™ is the next generation of Honeywell pumps, designed and developed for maximum ease of installation. This technologically advanced pump features a high efficiency ceramic magnet motor with integrated rotor controller and integrated wear ring. Full-time integrated pressure switch ensures optimal performance in all applications.