Johnson Controls FTG18A-601R DIRECT MOUNTING PROBE FOR P32 P560

"DIRECT MTG PROBE FOR P32

The DIRECT MOUNTING PROBE FOR P32 provides a direct mounting capability for the P32 temperature monitoring display. The probe plug-and-play installation takes only minutes and eliminates the need to run wiring from the display to an exterior location. It also features a fully adjustable stainless steel rod that allows for precise positioning of probe tip from the mounting to the appliance being monitored - which is especially useful when monitoring an oven or other piece of equipment that requires tip placement within limited space.

Johnson Controls FTG18A-601R DIRECT MOUNTING PROBE FOR P32 P560. The probe is the only way to directly measure process media without placing a thermistor in the media. This probe can be used for low to mid range nitrification applications 2 to 2.5 ppm NO3."

The Direct Mount Probe for P32 P560 Thermostats is the right probe for the HVAC professional who wants to be sure to install the correct probe for each job. The Direct Mount Probe includes an Ivor Jones programming thermocouple with four feet of lead wire. It will mount directly on the R-32/35, R-410A or P32 high temperature series via accessory mounting bracket.

The Direct Mount Probe FTG18A-601R for the P32 and P560 provides you with the ability to monitor your buildings comfort directly from a touchscreen HVAC Control. A four conductor, 18 foot LCD display is included.

The FTG18A-601R Direct Mounting Probe kit is designed for P32 or P560 EnSeries controllers with the direct mount kit. This kit contains a probe support assembly, thermocouple, and an extension cable kit.

The FTG18A is a direct mounting probe for the Johnson Controls P32/P60 split system mini-splits. It is designed to control a heat source, such as a floor register or forced air convector, from the thermostat of the mini-split. It does not have its own display or controls.

Easily monitor and control airflow and temperature in your home with the FTG18A-601R direct mounting probe. It is designed for use with existing Johnson Controls thermostats, such as the Johnson Controls P32 and P560 (sold separately). Just call and we'll take care of the rest.

The Thermistor P32 is a direct mounting probe for use with the Johnson Controls Metasys P Series and Q Series control systems. Viable as a standalone or as part of a complete solution, this humidity and temperature detector is easily installed and configured on the network. The probe operates as an intelligent remote sensor that transmits readings out of site to the control system, eliminating the need for onsite display and manual data points.

Adapted for use on buildings with existing voice alarm systems the FTG18-601R direct-mounting probe can be installed quickly by using existing riser cables. The probe is specifically engineered to provide superior performance in buildings where high levels of false alarms result in frequent attention by security personnel. It is designed for use with fire alarm systems that incorporate voice technologies, such as voice evacuation and personnel communication.

The FTG18A-601R is for those who need a permanent mounting option. This probe comes with a 2" NPT x 3/4" OD Flange and thread sealant. The calibration is set to closed for this use and it is designed to be screwed into the manifold and left in place without any adjustments needed after installation.

The FTG18 A-601R Probe has adjustable mounting brackets for direct mounting of the probe on top of the thermostat module. The dial is located at the front of the probe which makes it easy to read.

The Johnson Control FTG18A-601R is an 18A 600VAC fused power disconnect. This product has a removable clamp to allow easy installation of accessories like air compressors, heaters, for test for example. Also features an adjustable mounting bracket allowing the probe to be used in tight spaces."