Johnson Controls T-4506-202 Dual Temperature Thermostat with Indexing Switch, Direct Acting, Vertical Mounting,

"DualTemp

The DualTemp Programmable Thermostat provides two independent programs for both heating and cooling. The easy to use design includes a large, easy to read LCD display and the convenient indexing display. The large LCD display is designed with a negative (-) or positive (+) indication for very easy programming without having to set the dials.

The DualTemp Thermostat provides two different heat settings in one unit with an Indexing Switch. Your comfort is increased by programming your specific temperatures for both heat and air conditioning. Thermostat comes with 6 ft. cord and connections. For use with gas, oil, electric baseboard, wall furnace/furnace circulating fan, hydronic (hot water) baseboard, electric radiant floor heating, hot water circulation boiler.

Customize to your exact comfort with the precise temperature control of a DualTemp System

Johnson Controls T-4506-202 Dual Temperature Thermostat with Indexing Switch, Direct Acting, Vertical Mounting, -40 to 180 Degree Indicating Range A high limit control for use on hot surface furnaces or other equipment where a broad temperature differential exists between the heating element and the furnace. Vertical mounting only. A truly dual purpose thermostat for both direct and indirect applications.

The Johnson Controls T4506-202 dual temperature thermostat with indexing switch, direct acting, vertical mounting is designed to control most gas/oil heaters, electric heaters, packaged terminal heat only units and radiant only systems. This thermostat supports up to 2 heating stages or 1 heating stage and one cooling stage. The thermostat is designed for vertical mounting in the field, dry spaces. U.L. listed for safety.

This thermostat is designed to control two baseboard heaters, radiant heat areas, etc. The switch allows the two sections to be operated independently for either heating or cooling. The switch is 'indexed', so that when in-between settings or moving back off of a setting one incremental position is required after the switch has returned to the normal off position.

A direct-acting, room thermostat that combines high accuracy with simple, fast installation

Add a dual-stage thermostat

Control two heat sources independently with a Johnson Controls Thermostat. This JCI direct acting, vertical mount thermostat allows you to select a delivery rate from a lower setting to a higher setting and switch between these set points without having to reheat. The thermostat switches from "D" to "F" or from "F" to "C".

This thermostat can operate two ton systems. It has a low voltage terminal block to be wired with 10 gauge wire to G, Y, W1, C and R wires at the top of the terminal block. The J2 connection is to be wired with 18 gauge wire to control Y, W1 and W2 terminals on the coil at the bottom of the terminal block.

The 8000B/D10K resistor has indexing switches that change the operating set point of the device to either 250 ºF or 145 ºF. The rated current is 0.5A @ 120VAC. The maximum voltage is 240VAC.

Vertical mount