Lennox 12W47 Inducer Assembly

Inducer Assembly

This Inducer Assembly is the number one heat induction brand in North America, and a name people know, trust, and prefer. It has a solid cast rotor, die-cast aluminum stator plate, and is made in the U.S.A . This Inducer is built to last.

If you are looking for the replacement Inducer Assembly, invest in the Lennox 12W47 Inducer Assembly. This Inducer Assembly is an important component if you are using your furnace and need to get your system running again. The Lennox brand is known for manufacturing some of the best products out there. It is a high quality product that lasts longer and works efficiently because of its good design.

The Lennox Inducer Assembly is a product that converts a three-speed blower to a four-speed blower. It is only used in specific air conditioner/heat pump models.

The Lennox 12W47 Inducer Assembly is designed to fit and replace worn out originals. This low cost inducer will ensure your furnace remains in peak working condition.

The Lennox 12W47 Inducer Assembly is a genuine Lennox Inducer/Igniter Assembly. This inducer assembly is designed for use with the following Lennox model applications: MR54P, MR54VHAT, MX53P, MX53LHAC, MX53LHAI, MX54PAHP, and MX543.047PEF.

A Genuine Lennox inducer assembly is specifically engineered to fit your Lennox residential or commercial unit, so you can put your mind at ease knowing that your system is operating at peak performance. Your inducer assembly can get damaged during a normal cycle in your heating and cooling system, but it can be replaced by a professional without having to replace the complete unit. By just replacing the part, you will save money while ensuring optimum system efficiency.

The Lennox 12W47 inducer assembly is used in the L5205C, L5211C, and L5212C model furnaces. Note that the correct alignment of the wires within the harness connector is critical and this must be accomplished before attempting to install the inducer into the furnace. A visual inspection of the assembly should reveal if enough wire has been routed into the connector; if not, additional wire must be added before proceeding with installation.