A.O. Smith & A.O. Smith 100208662 Probe for Low Water Cutoff

Probe for Low Water Cutoff

Smith and other brand water heaters that use 2-wire low water cut off switch with female terminals

A

Smith GWS88, GWS88DVLP, ASME, C3 and C3H Indirect water heaters to shut off the water supply if the incoming cold water supply drops below a certain level to prevent damage to the appliance from a lack of incoming water

Smith 100208662 probe for low water cut off is designed to replace an existing switch or actuator in your pool and spa water treatment system

Significantly reduces installation time by simplifying wiring connections and clamps compared to the conventional coil wire connection, where a clamp is required on both sides of the valve

Smith systems that need updating or replacing

Smith Probe for Low Water Cutoff is a highly accurate and reliable probe used to shut off the water supply to a water heater if the water level falls below an adjustable threshold

Smith & A

O

Smith whole house pressure reducing valves and A

They are perfect for any A

Replace your old, outdated parts with these A

It features a 12 in L sheathed cable and a slim design

Smith 100208662 Probe for Low Water Cutoff is a device that measures water level in a toilet tank and will shut off the water supply to the tank when the water level reaches a certain point, or may be set to shut off at any pre-set level between full and empty, using a dip switch on the probe assembly

Smith 100208662 Probe for Low Water Cutoff is designed to fit A

Smith 611-100208662 Probe for Low Water Cutoff installs on the A

The probe has a stainless steel body with a UV resistant polymer tip, and can be used with many A O Smith models of pool and spa water treatment systems

These high-quality probes will make sure you get the best performance out of your A

The A

Smith 100208662 Probe is used on water heaters with point-of-use electric heating elements that have low-water cutoff for automatic shutoff when the tank has reached a low level of water (not compatible with tankless water heaters)

Smith replacement parts

Provides protection against overheating and dry-firing, thus helping to prevent damage to the water heater caused by malfunctioning thermostat or switch assembly

Smith system by helping to regulate and maintain the water level in your tank, preventing water from leaking outside of the tank and onto floors or furniture and causing damage to your system and belongings

Smith 3/4 in Low Water Cut Off Probe is designed for use with gas or electric hot water heaters with a maximum operating pressure of 125 psi and temperature of up to 175 degrees Fahrenheit and may be used with hot water tanks or tanks equipped with expansion tanks, as well as boilers fired by oil, gas, steam, or electricity

This probe is used for A

Smith low water cutoff valves

This A

Smith 100208662 Probe for Low Water Cutoff, 2-Pack