LOW PRESSURE SWITCH for Iceomatic - Part# 9041104-101A

LOW PRESSURE SWITCH for Iceomatic - Part# 9041104-101A

LOW PRESSURE SWITCH for Iceomatic Part# 9041104-101A used to turn on pump in case the pressure switch is faulty. This part comes with the pump-lever-bobbin

Low pressure switch for use with Ice-O-Matic IceMakers. Part numbers include: 9041104- 20, 9041104-101, 9041104-091, 1006373

Iceomatic uses water pressure to move ice from the ice maker to your icemaker bin. Water enters Iceomatic below the low pressure switch and exits through the low pressure switch. The purpose of the low pressure switch is to prevent excess water from exiting the valve, and moving into the home or flood condition. If excessive water enters Iceomatic, reverse flow can occur causing structural damage. Therefore, this part is important on Iceomatic.

Low Pressure Switch for Ice-O-Matic ice machines. This part is designed to require replacement, which will occur as a result of the Gel-Tub leak test protocol.

The low pressure switch assembly is for the Ice-O-Matic ICM4500 and ICM8500 compressor assembly. The low pressure switch activates an indicator light on the control panel when the compressor discharge pressure falls below a predetermined level.

Iceomatic's exclusive Self-Diagnostic system identifies defective parts and reports failures. Our new switch has a "wet" connection to sound the alarm when the line leaks. This switch mounts onto the side of the ice tube. Switch is neatly covered with a foam pad for quiet operation. The thermostat must be reset after changing this part. Iceomatic requires only one of these switches for a whole system.

The Ice-O-Matic Low Pressure Switch Kit is designed for use with Ice-O-Matic Undercounter Ice Makers that are installed in ice machines with an air pressure switch system. The kit works with the following products: TK600C, TK800C, TK900C, and IC400C.