MARS 33215 Replaces Klixon HQ 705615 TX SEQUENCER

Sequencer

Sequencer

The SEQUENCER is a wall-mounted controller for up to 5 KLIXON load center branch devices used to control non-emergency lighting and power devices. It offers latching, not holding, automatic circuit protection by allowing programmable output control and muting overcurrent.

On/Off Sequencer

The SEQUENCER controls the operation of the toilet and teapot through a timer with simple on/off functions, and a time delay for the toilet. It does not require any specialized skills to set up, and provides an added level of safety by ensuring that both devices will not operate at the same time, as can happen when using a manual switch attached to each device.

The control for your electric water heater is a safety device installed in-line on the water heater control circuit.  When the water heater thermostat opens, the sequencer shuts off the power to the element until water flow is restored. Without a working sequencer, continuous cycling of the recirculation pump could result in overheating and damage to your tank.

The Mars® Valve Sequencer, when installed on any one of the 80+ Mars Valves, will enable smooth switching between hot and cold water for radiant floor heating systems. It cannot be used with instant water heaters or boilers. The Mars® Sequencer is intended to replace the existing HQ 705615 TX compressor valve sequencer kit and also includes a manual temperature adjuster with two (2) hoses that attach directly to the valve.

The MARS® Seq+® series of single-channel sequencers are compact and economical for precise, easy­-to-grasp sequential control. The simple MicroLogix 1000­-style programming interface and clear LED status indicators make programming straightforward.