PRESSURE CONTROL FAN CYCLING HIGH PRESSURE REFRIGE
Pressure Control Fan Cycling High Pressure Refrigerant Machine Accessories kit. For those Service Technicians looking for a way to cycle the unit faster then Johnson Controls has the solution you need.
A pressure control fan cycling high pressure refrigeration machine accessories kit is made up of a motor assembly, pressure control, and a temperature control. The kit is used in heat cycle centrifugal chillers.
Pressure control fan cycling kit for R410A refrigeration equipment. Kit includes: pressure cut relay, pressure switch, wire harness, snap in fittings, and operating instructions.
Pressure Control Fan Cycling switch provides additional features. Temperature differential is maintained by cycling the pressure control fan on or off to ensure that the discharge air temperature does not exceed the set point. This prevents condensation and saves energy by making fewer trips to ice down. Ideal for downstream cooling applications, this system will cycle off and back on for up to an hour when the discharge air temperature reaches one degree below the set point..
Pressure control fan cycling - Module assembly controls the cycling of the compressor based on pressure or temperature. It is installed between the vaporizer and the condenser coil in heat pump systems.
The Johnson Controls 3/4" PXV-A kit converts a single pressure switch, with or without a cooling tower, to fan cycling. The kit includes a replacement pressure switch to convert a standard 4-wire system to fan cycling; Pressure regulator; power supply for the pressure regulator; and an adjustable, 120 volt spring return orifice plate. For use when varying heat loads on rooftop units require the compressor to cycle while cooling load remains constant.
A fan cycling kit is a valuable accessory to have if you need to manage the pressures in your refrigeration equipment. The cycling kit works with any refrigeration machine equipped with quick disconnect facia valves.