Honeywell 66975 UNIVERSAL ANALOG INTERFACE MODULE WITH ENCLOSURE

UNIVERSAL ANALOG INTERFACE MODULE WITH ENCLOSURE

This Honeywell 66975 Universal Analog Interface Module with Enclosure (Anat) is a terminal-block mounted analog control interface for condensate pump applications. This Anat is designed to be mated with a Honeywell Flo Pro 2 Phase Condensate Pump and works with 3 wire 3 or 4 wire 5 volt logic controls to support dry contact control of the pump's run, auxiliary relay and aux heater contacts.

The Honeywell 66975 Universal Analog Interface Module with Enclosure can be used in any of the most popular legacy Honeywell alarm panels or as a stand-alone device to provide multiplexing services. This low-cost interface module is easy to install and allows you to connect either an external wireless receiver or up to five separate wired sensor devices. It features fault indication, 24 volt DC power supply, and no internal battery required for operation.

The Honeywell 66975 Universal Analog Interface Module with Enclosure installs on Honeywell security systems to enable universal appearance and enhanced functionality..

The Honeywell 66975 universal analog interface module with enclosure allows you to connect a single analog device to any wired or wireless alarm system. The module works with most commercially available systems and can be used in both residential and commercial applications.

Honeywell's 66975 Universal Analog Interface Module with enclosure is a 4-20mA output analog input module designed for use with the 66800 (8-zone) Universal Communicator and Telemetry Processor. It accommodates up to four subsystems, and each subsystem can be individually programmed to meet specific applications.

The Universal Analog Interface Module enables data transfer between a Honeywell network system and an external user device. The analog module allows the user to access various inputs from a control panel utilizing three (3) wires

The 66975 Universal Analog Interface Module offers a complete replacement for the Honeywell 66924 Universal Analog Interface . A total of 16 analog inputs are provided to connect external sensors and controls to compatible thermostats. The powerful microprocessor in the module automatically identifies the type of signals being received from the devices and assigns them to appropriate registers (inputs or outputs). Current is continuously monitored to ensure against over-current conditions, and an open drain output is provided for alarms and troubleshooting.