My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New Account
Free Shipping
In stock
2 days
RAM BASE
4-1/8" (105 mm) x 1-3/16" (35 mm) x 3-1/2"
This plate is made of high tensile steel for durability and extended service life
OTC OTC1230 () Cylinder Sleeve Removal Plate is designed to remove the sleeve from Type 1 and Type 2 oxygen cylinders
The OTC OTC1230 () Cylinder Sleeve Removal Plate is used for removing a new cylinder sleeve from its rod during installation
Pads are made of a non-marring nylon plastic
The Cylinder Sleeve Removal Plate is designed for use with a 3/4" wrench
This is done by using a pulling tool that fits into the retention slot in the plate
Sleeve removal plate for OTC 1230 Cylinder Sleeve Puller
It is recommended that the OTC1230 (Cylinder Sleeve Removal Plate) be tested on cylinders before using it on damaged cylinders
Plates are made of a non-marring nylon plastic
The OTC1230 cylinder sleeve removal plate is designed to remove the sleeve and piston from a thermoplastic cylinder
The Cylinder Sleeve Removal Plate is used to remove a cylinder from an OTC actuator
The sleeve can then be slid over the rod and onto the cylinder head
The actuator rod is inserted through the rod opening in the plate, and contact with the retaining ring forces the plate outward, removing cylinder from the actuator bore
OTC OTC1230 () Cylinder Sleeve Removal Plate: OTC OTC1230 () Cylinder Sleeve Removal Plate with Handle
It is designed as a one-piece unit, with no moving parts to wear out or replace
The Sleeve Puller Plate can also be used as a paddle valve wrench
Cylinder Sleeve Removal Plate for OTC 1230
The OTC1230 is a sleeve puller plate designed to remove and install cylinders on cylinders equipped with sleeve puller rings
The nylon plates and pads will not stick to the cylinder or damage it
It is compact and lightweight for easy handling and storing
OTC OTC1230 () Cylinder Sleeve Removal Plate
OTC1230 Cylinder Sleeve Removal Plate
The plate is placed on the sleeve, between the retaining ring and bore wall
Includes handle for ease of use
2 days
K Tool International
This is a 2 ton tripod underhoist stand. It is made of heavy duty steel and is perfect for use with underhoist systems. It has a capacity of 2 tons and is easy to use.
OTC
The OTC-1778B 12-Ton Capacity Low Jack Stand is a heavy-duty jack stand that is perfect for use in a variety of applications. This stand is made from steel and is able to support a weight of up to 12...