Rheem-Ruud RXHP01 SENSOR/CLIP ASSEMBLY

SENSOR/CLIP ASSEMBLY

For the ultimate security, choose a sensor/clip assembly like this one from Rheem-Ruud. This sensor/clip assembly has a maximum supply voltage of 44 volts, and comes with two 2 pole, 24 volt actuators.

Rheem-Ruud Sensor/Clip Assembly. Sensor may only be used with Clip Assembly .46N9XA Ss Sensor/Clip Assembly; R1513584 - 1 Tl4216115 Clp Assmbly For Ruud S2 Lt 3/5 And R

Use the Sensor/Clip Assembly to repair a Ruud Rheem heating and cooling outdoor unit (RXHP01). The Sensor/Clip Assembly connects to the outdoor unit's compressor. This is a genuine part, made from high quality materials, and comes with a one-year warranty.

Rheem-Ruud's RXHP01 Sensor/Clip Assembly is designed for use with Infinite-Cycle horizontal blower furnace actuators. The RX series Sensor/Clip Assembly can be used as a direct replacement component and ensures dependable performance through years of use.

Our Rheem-Ruud sensor/clip assembly is used in the outdoor models of specific Ruud heat pump units, making it ideal for replacing your malfunctioning or broken part. It is easy to install, and includes a 1 year limited warranty on parts and labor that is sealed into the product.

Rheem is continuing its tradition of manufacturing top performing products that are reliable and durable. The Rheem Ruud Heat Pump System with TXV, RXHP model includes coordination with a new sensor/clip assembly. This sensor/clip protects the heat pump from a variety of conditions. The sensor is made from thermoplastic to withstand harsh outdoor conditions.

Rheem-Ruud Sensors Clip Assmblies Are Designed And Built To Meet Or Exceed Original Equipment Specification. All Representatives, Distributors Or Dealers Of Rheem-Ruud Equipment Should Be Advised That Any Attempt To Substitute Any Unauthorized Components Will VOID The Rheem-Ruud Warranty.

CLIP-ON MOUNTING REQUIRES NO CUTOUTBOARD NEW DESIGN EASY TO INSTALL SENSOR WITH BUSHINGS

The Rheem-Ruud Sensors and Clips are designed to be installed into gas water heaters with 1/2'' diameter, full port piping to eliminate the problems that corrosive water can cause: Increased maintenance costs and equipment failure. The sensor will trip off when it senses potentially damaging levels of limescale and/or corrosion; supplying protection for your heating system against costly breakdowns.

Rheem-Ruud Sensors are designed to work with Rheem-Ruud actuators. These sensors have a BNC connector with an output of 4-20mA. One edge of the sensor has two channels for 2 heating elements, and the center of this edge has two channels for 2 cooling element. The sensor also has a clip that is attached to the other edge which holds the new element in place.

Rheem-Ruud's RXH Series Actuators provide true remote piloting capabilities and exceptional ease of use.RXH Series Actuators are available in single, Three phase (S & T with NO/NC and NC/NO) and DC models. RXH Single Phase (+E), Three Phase (S & T w/NO/NC + NC/NO), DC model available.

This clip is suited for various applications where a clip is required.