YORK S1-02432004000 CNTCTR 2PNO,30A,24V CNTCTR 2PNO,30A,24V

24v Coil 2P 40AMP CONT

This unit is designed to allow for simple plug and play installation of electronic devices such as temperature controls, controllers and timers. Contactor is rated 30Amp 300VAC Non-Interlocked N/C (Normally Closed) 2P. Coil is rated 32VDC 40AMP with screw terminals.

This contactor is used with 30 amp load of 240v

Primary and secondary relay contacts rated 40A @ 240VAC. Used in tandem with a high voltage thermostat to control forced air furnace or air conditioner unit.

The York CNTCTR 2P NO, 30A, 24V is one in a series of miniature circuit breakers that comes in either single pole or two pole breakers. The breakers are marked with their current rating to make it easier for users to select the right product. The circuit breakers are designed for use with plastic consumer products ranging from VCR's, microwaves to light switches.

A coil becomes part of the motor assembly and is energised whenever the motor is operating. The resistance of the motor and the heating effect of this current cause eventual failure of the components. There is a maximum limit to the time and distance that a combination can be operated without causing damage either to the rotor or stator. This coil has been specially designed to operate effectively in such an environment

The S1 Series Contactor is used to disconnect the starter winding of the motor from the power source when the motor has reached its run-down torque value. It can also be used as a starter switch for reversing motors by simply changing the connections at the terminals.

This NEMA 4X cage nut indoor circuit breaker from the S Series from York Electric is a perfect solution for your electrical needs. This indoor, one pole, 30 amp circuit breaker has a thermal magnetic arc suppression type and a continuous operating current of 40 amps. The S1-02432004000 has a voltage rating of 240 and a voltage leg length of 4. To ensure safer operation, this circuit breaker is equipped with set screw terminals and a tightening capacity of 1/2" or 20mm. It also has a lug width of 5/16" or 8mm and features an interrupting capacity of 10KAIC