York 144367 S1-025-35366-010 PLU 12 CIRCUIT BREAKER JUMPER

PLU 12 CIRCUIT BREAKER JUMPER

Jumper is used to connect two adjacent panels to a single device. PLU 12 Circuit Breaker Jumper can be used for several applications including connecting PLCs, relays, contactors, etc. The jumper comes with mounting brackets and screws. The units are UL listed and CSA certified

Siemens Electronics makes operation easier with the 12 Circuit Breaker Jumper for the York RT35, RT40 & RT44.

Be sure that you are getting the right product with this circuit breaker jumper by using the number printed on the product. With this Circuit Breaker Jumper, it is possible to successfully connect 120 volt loads to 240 volt circuits.

Available in both 120 or 240 volt, this circuit breaker jumper is perfect for switching two circuits to either different phases, or to the same phase. The black/green color code matched to color-coded electrical wiring minimizes wiring errors.

The York S1-025-35366-010 circuit breaker jumper is a replacement 2 pole 2 wire circuit breaker jumper. This includes a 30 amp rating and some models have been manufactured from June, 1992 until December, 1996. The power rating on this circuit breaker jumper is 20,000 amps at 480 volts/277 VAC.

When a breaker is tripped, the S-025-35366-010 must be manually reset. If a switch or circuit breaker fails to operate normally, you will need to jump it off with a jumper wire to restore proper current flow. This is because current will usually pass from one side to the other through the loops in the springs of the switch. In rare instances where there is a break or open in a circuit, current will not be able to pass from one side of the switch to the other. In this case, a jumper must be used to create an alternate path for electricity to flow.

The Jumper is a multifunctional jumper with a board mounted 120 V receptacle and T6 screw terminals. This portable jumper can be used as an extension cord and replaces lost or damaged cables.