YORK S1-02545231000 S1-02545231000 IGNITER,SILICON NITRIDE

IGNITER,SILICON NITRIDE

YSD1-02545231000 is mainly used in diesel engines, gasoline engines, agricultural machinery and mining machinery. As the ignition equipment that ignites the fuel, the function of igniter is to connect the engine switch; When the engine is started, it will send current to function with high ignition trigger voltage and instantaneous power output to ignite the fuel.The IGNITER,SILICON NITRIDE YSD1-02545231000 must be properly installed so that it

A silicon nitride igniter is an electrical device used in gas appliances for ignition of the pilot flame. A person typically uses the igniter to light a burner on a gas stovetop or oven. In the case of a gas stove, an electric switch or timer turns on the power to a small coil that sends an electric current to the igniter. The igniter contains a built-in pyrophoric substance that creates sparks to ignite the gas. IGNITER,SILICON N

The Igniter, Silicon Nitride igniters, have a long life of greater than two million operations. The Igniter is mounted in the combustion head by a threaded ceramic ferrule to protect it from the extreme temperatures inside the burner head. Two high performance Igniters are used to prevent degradation due to arcing or mis-alignment of front and rear igniter barrels. These igniters are supplied wired and ready for installation.

Igniters are designed for use with electric air blowers.Available in silicon nitride and silicon carbide provides you with a choice of two materials with different strengths and corresponding levels of ruggedness. Silicon nitride is harder than the familiar SiC and can withstand greater pressure.

The Igniter, Silicon Nitride is a key component to getting an appliance to work. It provides the voltage needed to ignite the gas from the Air Switch. The Igniter is forgiving when it comes to different voltages, amperages, and conditions.

This Igniter is a nonresettable device that contains two or more silicon nitride bridge - wire segments in the shape of alligator clips. One strand is connected to a high resistance ignitor wire and the other strand to the ground terminal. The silicon nitride produces a long lasting (approximately 10,000 hours) high temperature (approximately 5,000 degrees C) arc.

The S1 series igniters are silicon nitride thermal-rite resistors. These devices are a silicon nitride resistor incorporated into a ceramic housing. The devices provide high tensile strength, allows for minimal weight increase, and have low creepage distance to accommodate large wire sizes. It is used in applications using high current or pulse width.