SCHLAGE PS902 Electronics 2-Amp Class 2 Power Supply with 4-Relay Output Board and Fire Alarm Interface Board, 12/24VDC Output, 120/240VAC at 50/60 Hz Input

PS902 2 AMP POWER SUPPLY

The PS902 is a 2 AMP power supply with 4 relay outputs for the Fire Alarm Interface Board PS902. This allows for powering 110VAC devices in single phase, up to 2 amps. The power supply can be used with 24VDC and 120/240VAC inputs and outputs.

The PS902 is a 120/240VAC at 50/60Hz 2 amp Power Supply designed to provide power to all models of Schlage Fire Alarm Interface Boards and 2-relay output boards. It also contains a universal power supply that is designed to work with virtually any AC electrical device from a 12V DC battery down to 9VDC. The unit is compact and lightweight making it perfect for use in both residential and commercial applications.

The PS902 Electronics 2-Amp Zone Power Supply is a combination of both the power supply and relay board designed to monitor all system zones. The zone relay board provides the ability to monitor up to 6 different zones for low, dead, and normal conditions per zone.

The PS902 is a power supply device which provides two channels of power distribution over a 120V or 240V, 50 or 60Hz AC line. Each of the two channels is capable of providing a maximum of 2 amps. The PS902 has fifteen terminal blocks, thirteen six position terminal blocks and two four position terminal blocks. Eight of the terminal blocks are connected to 120VAC terminals, eight are connected to 120VAC/240VAC center tapped output and three are connected to the high voltage terminals (24VDC). The PS902 contains an internal fault detector that will disconnect any supply output when an

The PS902 Power Supply converts 120/240 VAC to 12 to 24 VDC power for fire alarm control panels. The external dimensions are 4.0" W x 8.9" D x 2.9" H and the output current is 2 amps at +12VDC operating voltage with up to 5%. The input voltage range is 100-240 VAC, 47-63 Hz and output is 12VDC at 300 mA maximum per relay. There are 4 relays with different set times on delay and a buzzer for alarm signalling. A front panel switch sets off all relays simultaneously with short

The PS902 is an AC constant voltage DC switching power supply with 4 relay output board and fire alarm interface board, 120/ 240 VAC switchable. It is designed for applications that require 2 amp at 12VDC or 24VDC with fail safe voltage range from 10VDC to 38VDC. This power supply has an IEC320 removable fusing system and built in over current protection.

The PS902 is a power supply designed to work with Schlage 5800 series and most other fire alarm control panels. With a wide range of input voltages (12 to 24VDC) and a broad range of output voltages (12 to 240VAC 50/60Hz), this power supply is capable of interfacing with most fire alarm systems.   How can we help?