ERIE VT2212G13A020 Schneider Electric () "1/2""Swt 2w 2.5cv NC 24V SR"

"1/2""Swt 2w 2.5cv NC 24V SR"

The Schneider Electric () "1/2""Swt 2w 2.5cv NC 24V SR" is a type of product manufactured by the company listed above. If you wish to learn more about this product, visit the following website link:

The ERIE VT2212G13A020 Schneider Electric () 1/2""Swt 2w 2.5cv NC 24V SR is suitable to be used in 12Volt 24Volt operation & it provides ERIE with Eaton a quality product that provides the best & reliable system protection and control.

Schnieder Electric (ERIE) has a cord in switch rated 1/2"Sv 2w 2.5c-v 24V Sr with no rating plate, enclosed in a vertical brick wall mounted box. I'm looking for the wiring diagram or schematic to find out the amperage/voltage connections. Or someone who can tell me how many amps, watts and volts this device uses.

The 1/2"(14mm) 2-wire 10A Switched, Current Limited Control Relay has a 24V DC coil voltage and a maximum switching current of 2.5A. It features a minimal operating voltage of 6V DC and maximum switching voltage of 30VDC. This 1/2" control relay provides overload protection with 110% rated current tolerance and has short-circuit protection within the switching capacity. It also has terminals for both Normally Closed (NC) and Normally Open (NO).

The ERIE [VT2212G13A020] power adapter is equivalent to the APC model VT2212G13A020. It is a high energy efficient switching power supply that converts line voltage to lower voltages for use by computer and other devices. The power adapter provides maximum input power of 120 watts and output voltages of 24VAC (Volt-Ampere) at 2.5 amperes, 115VAC at 2.5 amperes, and 20VDC at 2.5 amperes, with a total continuous output current of 7.3 amperes (

These 4-wire quarter-turn snap switches are the very latest in safety for panel boards. They are designed specifically so that fields that might start arc or flame upon turnoff can not be turned back on unless the switch is turned back on first. This simple change to an existing system eliminates the problem of a switch that cannot be turned off starting an arc or flame at a remote location during shut down. The new design also has a floating ground and positive leads that are connected directly to the load terminals. There is no voltage between the contacts while they are closed. This makes these switches far safer for panel operation

25 foot Marine-Grade electrical cable with wiring plug for boat