SCHNEIDER ELECTRIC LC1D80B7 -Square D 24V 80A 3P Contactor W/Aux.

24V 80A 3P Contactor W/Aux.

A common application is for the removal of oil from wastewater and bilge water, where it is required that some of the oil be diverted into a separate storage tank (eg, recycled back to the engine through an overboard system) while some is removed from the vessel as waste

The PNEUMODIVERTING RELAY is a pneumatically operated switching device used to route the air flow from a process line to either an auxiliary vent or drain

The relay is designed for use as a main on/off control device in pneumatic motor control and similar applications

The Schneider Electric Pneumodivert kit provides automatic control of a diverter valve to prevent overpressurisation of the central heating system

DIVERTING RELAY is a microprocessor controlled, diverting output relay with internal DIP switch for selection of energizing, non-energizing or alarm conditions

5 amps at 24 VDC

Easy to install and with a long service life, this relay will perform reliably when you need it most

When the relay is activated, the valve diverts the liquid to be treated to either or both of two outputs

It can also be used to divert liquid into different storage tanks by connecting a number of these devices in parallel

The Schneider Electric 2353-502 (Barber Colman) "PNEUMOD

Two-pole, normally-open (NO) non-latching relay with operating characteristics compatible with Pneumatic/Electronic four-20 mA transmitters

It has a maximum switching capacity of 4 amps at 30 VDC and 0

When you need to switch and divert air or gas flows in multiple directions, trust the robust, dependable Pneumatic Diversion Relay from Barber Colman

PNEUMOD

Schneider Electric 2353-502 Pneumatic Dividing Relay

It is normally used in conjunction with other air/gas control devices, such as pressure relief valves and pressure switches, to protect the main process line from excessive pressures and vacuums

The 2353-502 Diverting Relay consists of a relay and an electro-magnetic valve

DIVERTING RELAY is a 5VDC-Rated Pneumatic Diaphragm Air Switch, 2-Position Diverting, Normally Closed

The 2353-502 (Barber Colman) "PNEUMOD

It can be used to sense one or two ranges/zones and switch three or four outputs, or sense only one zone and switch up to six outputs

Schneider Electric 2353-502 (Barber Colman) "PNEUMOD

This unit is configurable to meet the requirements of a wide variety of applications

It consists of the barber colman 2353-502 relay, 24 VAC power supply and mains filter, pressure differential switch and all necessary wiring