"2.5"" 2P FloatSwt;Close On Rise"
The Square D 9037,2.5"" 2P FloatSwitches Close On Rise is a safety device for control and protection of electrical circuits or equipment. It is used in normally open or normally closed applications to provide overload protection for motors, pumps, resistive heating devices, and similar equipment.
The Schneider Electric #9037HG32 Square D float switch is designed for use with a power circuit. It has a side mount position and a 90-degree float rod angle with an offset of 7 inches (177.8 mm). This float switch has a 90-Degree setting. It features contacts close on rise and a 270-Degree setting. This product is UL listed and has been tested by Intertek according to CSA C22.2 No. 79-M1986 standards for safety.
This float switch protects a circuit, closing the contacts on a rising liquid level in a tank or pool of water for use as an overflow protection. This float switch is suitable for use in fresh water applications only and should not be used with any application involving oils or chemicals.
Reduce energy loss by keeping your equipment safe from low water or oil with this Schneider Electric 9037HG32 Square D 9037 tank float switch. This side mount float switch has a 90 degree angle on the rod, allowing it to be mounted horizontally or vertically, and features contacts that close on rise for enhanced reliability. It comes with stainless steel hardware.
This Schneider Electric 9037HG32 Square D 9037 Closed-Tank Float Switch in silver has a 7"" offset and is meant to be mounted side-by-side against a wall or first floor with no overhangs. The side-mounted, closed tank switch can be used with either the left or right float position. The 9037HG32 Square D 9037 has both a rise and fall contact configuration that operates on low voltage circuits 120/240VAC.
This brand new Schneider Electric 9037HG32 square d 9037 closed-tank float switch features a 7" wide offset for additional clearance. It's made of high-impact resistant plastic and comes with bushing. This float switch features a 90-degree mounting angle, with left side mounting, which are both designed to accommodate vessels or other equipment that mount to the right side of the tank. The length of the lead wire is 10", and designs to be installed inside closed tanks.
This 90-degree floating, square tank switch features a 3/4"" 4/0 cu copper bushing with 18 ga contact and 22 ga bevel trim and hanger.
Free Shipping
In stock
