Honeywell 6550 , Inc. Pneumatic Diverting Switch, Three-Position, Panel

MANUAL DIVERTING SWITCH 1 POLE

INTENDED USE: These manual diverting switches are used on pneumatic control systems to divert the output of a normally open device to an alternate outlet.

The Honeywell 6550 Inc Pneumatic Diverting Switch, 3-Position, Panel is an industrial grade switch that is a manually operated diverter with a three position control lever. It moves one wire from one terminal to another at a time.

Three position pneumatic diverting control switch which has a trip free contact, manual switch can be used normally open or normally closed. The mechanical switch is an adjustable angle design that controls the diverter to operate at any point.

The DT6550 Series Diverting Switches are designed to divert gas flow from one source to another in order to control the failure of a main input or airflow source. It consists of a pivoting lever (R1) controlled by the gas pressure being applied to a side port gas pressure controlled pilot (S) in the diverting switch body. The DT6550 Series is available in several versions with the choice of one through four positions, various cable lengths and six toggle switch levers.

Honeywell's Series 6550 3-Position Diverting Switch is a low-voltage, pneumatic switch that provides the function of direct connection to one device or an alternate configuration with the addition of another pneumatic control circuit.

The Honeywell 6550 Pressure Reducing Diverting Switch is designed for pressure reducing regulators. It can be used to divert full supply pressure to a downstream line to test the regulator, or convert the high pressure downstream back to a low pressure when the upstream line pressure is below that of the regulator setting. This switch integrates with all standard actuation systems.

Switching device, diverts air from one point to another, such as air flow from a manifold or output from a push-pull control. Manifold Air Service Valve not included.