OTC OTC6637 - Strut Tamer Ii Extreme

Strut Tamer II Extreme

OTC OTC-6687 () Cam Tool Set - GM V-6 Engines The OTC Cam Tool Set is the set of tools to use on GM 6 Cylinder Cam Systems

Used for adjusting cams in GM 6 cylinder engines up to 1990

The OTC-6687 () Cam Tool Set is designed for GM 6 cylinder V-6 engines

GM 6 Cylinder Cam Tool Set

GM V-6 Engines

This Cam tool set is designed for the GM 6 Cylinder engine

Camshaft Tool Set

OTC Cam Tools provide a quick and accurate method for checking camshaft timing and valve to piston clearance

The set includes the following tools: Cam Gear Puller, Combination Shim Puller, and a Crankshaft Alignment Bolt Guide

The OTC-6687 () set includes cam driver for intake, exhaust, and distributor shafts

The GM 6 Cylinder Cam Tool Set is used to hold camshafts into position in the engine block while cams are being installed

For use on V6 engines with one intake and one exhaust camshafts, including distributorless ignition systems

The set includes the following tools: J-Cam Holder, Bushing Driver and 3/8” Socket Drive Adapter

The gauge comes complete with all components necessary to perform alignment checks on GM V-6 motors up to 1992

Med Corp's Cam Tool Set is the perfect tool for all of your GM 6 Cylinder Camshafts

The OTC-6687 () is a complete set of camshaft holders and drivers, which allow the technician to measure cam timing as well as reset valve lash on all GM V6 engines

Contains two universal driver heads, an offset socket driver head, an extension bar and a universal joint

It includes the necessary tools to remove and install the camshaft and related parts of the valve train

OTC-6687 GM V-6 Engines Cam Tool Set

This tool set features the OTC-6687 Cam Follower Gauge, which can be used to check cam timing as it pertains to the piston position at TDC (Top Dead Center) and BDC (Bottom Dead Center)

Camshaft removal and installation tool set for Ford/Lincoln/Mercury V-6 engines