Johnson Controls 9268 SENSOR 1000 OHM NICKEL 1% FOR BEARING

SENSOR; 1000 OHM; NICKEL; 1% FOR BEARING

The SENSOR 1000 OHM NICKEL 1% FOR BEARING is a multipurpose sensor for use in all types of rolling bearings. The static load capacity is 0.012 lb f. It measures 0.500" in length, 0.250" in width, and 0.40" in height.

Johnson Controls 9268 Sensor, 1000 OHM, Nickel, 1% for Bearing

The SENSOR 1000 OHM NI-CR is a standard non-inductive resistor. This precision resistor has a current rating of 1A and frequency rating of DC to 10MHz. Production is performed in a nickel plated, glass filled polyester ABS insulated package with a protective nickel plate on the base.

The Johnson Controls 9268 Sensor, 1% Nickel (10-Pack), is a resistor that measures and regulates the current and voltage in a system. It is specifically designed for use in bearings, where it ensures efficient operation and extends the lifespan of the device. This part allows the motor to reach its target power slowly and steadily, for consistent reliability.

An extremely accurate taper sensing resistor with through-hole lead configuration, nickel over tungsten (N.O.S.) terminations to MIL-R-15005/4502, and resistance tolerance of 1%. 0.1% typical wafer TCR accuracy, very low temperature coefficient of resistance (TCR) of 0.01 ppm/°C to 0.03 ppm/°C (from -40°C to +85°C), and very low noise (noise level better than 0.5ppm).

Nickel sensors are used to monitor rotor bearing temperature typically found in parabolically dish shaped magnets. These parabolically dish shaped magnets are used for research and development applications. The nickel plates are attached to the magnet structure by epoxy at specific temperature points.

Amp;D Sensor is a manufacturer of moisture sensors, pressure switches, flow switches, pressure transmitters, flow meters, level controls, and temperature probes. We offer the largest selection of products at the most competitive prices in industry today. We offer several functional components for applications such as pneumatic switching, thermal sensing, and liquid level protection. Moisture sensors are designed to sense how much moisture is present in gas or liquid systems. Compressed air measurement is required where there is high moisture content from condensation, fogging or leaky duct work. Liquid level sensing is used to determine the level of a liquid

This is Johnson Electronics accurate replacement sensor element. It also fits the following models: - 899705-1001 - 83-89632 - L002

Johnson Controls Sensors And Measurement Products (SMP) business group, with its global headquarters in Milwaukee, Wisconsin, is now ISO 9001 certified. The organization now offers the M2R-Series of panel adapter products delivering state of the art features for commercial aerospace applications. These panel adapters are available with standard lead-times within +/- 1 week.