TILT SWITCH for Cleveland - Part# SKE003209-11

TILT SWITCH for Cleveland - Part# SKE003209-11

The Firelite SKE003209-11 tilt switch is made to fit specific Cleveland range models - 216T, 237T, 240T, 244T, 246T & 247T. This switch can be installed in replacement of your faulty switch or to simply add a new style switch to your cooking system.

The TILT SWITCH for Cleveland Gas Logs provides a current overload device required by the National Fire Protection Association (NFPA) and the Canadian Standards Association (CSA). This TILT SWITCH is intended for residential use only and cannot be used in commercial applications.

Tilt switch for use on the following Cleveland commercial hot water units. Red knob, white case with black lettering and 1 wire connection. Part numbers and additional information are located inside of the silver bag.

The tilt switch for Cleveland kiln controllers consists of a plug in tester that will check the output of the tilt sensor.

When your Cleveland tub drains slow, or stops draining completely, the problem could be the tilt switch. This independently tested and proven genuine replacement part will restore flow to your shower.

The Tilt Switch is used in the Archimedean Tilt Sensor (SKEP3 and SKEP5) to detect when the load cell has tilted beyond a preset angle and generate an output.

A Tilt Switch is a safety device that prevents compressor short-cycle from causing cabinet doors to be slammed shut.