Trane
Trane HED0766 HEAD
HEADThe Trane VAL10196 EEV Valve is a non-ICC registered product – Always consult local codes# Trane VAL10196 EEV valve is used for cooling equipmentIt will provide you with same performance as the...
My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountHEAD
SWITCH, SINGLE POLE, DOUBLE THROW (SPDT), 120 VAC, 9
Trane RLY1709 DPDT RELAY 24V, For use with the Trane ComfortLink II Digital Communicating System (DCS)
The product is for use with Trane systems only
The product is a DPDT Coil Relay 24V
This product is a general purpose relay that will operate with or without electrical power
(This relay requires a 24VAC transformer but does not include one)
The relay is used as a power switch to control energy consumption of an external device
This product is designed to prevent an air conditioner from over-cooling or overheating and will turn off the air conditioner before either of these conditions occur
The Trane RLY1709 DPDT Relay 24V is a direct replacement for the following: Lennox X259639, Carrier 58BRX25963, Aprilaire 62-1990A-110, Bryant 010-2092-00, Bryant/Carrier 58LX25962, Bryant/Carrier 58UAX25982, and Weatherking WK3082
Trane RLY1709 DPDT RELAY 24V Installation Manual
When the relay is in the OFF position, current cannot flow from the S terminal to either of the L1 or L2 terminal, and vice versa for when it's in the ON position
The relay is designed to allow current to flow to the load when the input voltage and the DCS output voltage are both low
This relay will allow you to remotely turn on/off a load up to 1000W at 24V DC
This relay is typically used to control equipment at 240VAC, but can also be used at 120VAC
The Trane RLY1709 DPDT Relay 24V switch is used to control one or two heating and cooling devices from one location
This is a Current Relay Module
This relay is designed for use with the Trane EcoNet™ Wireless Controller
Replaces Trane part number: (1) RLY1709
DPDT RELAY 24V 6A 120/240VAC 7
It can also be used with 24VDC systems by changing the voltage and/or wiring polarity