Trane MOT18964 200-230v1ph 1/2hp 1075rpm 2spd

200-230v1ph 1/2hp 1075rpm 2spd

The CNT1031 SPDT is a limit control used to sense temperature and actuate a limit control relay

Once you replaced it, you will be able to control the temperature of your heating and cooling systems more precisely than before

CNT1031 SPDT Temp Limit, Trane, for use with: Air Conditioning & Heating Systems, Control Type: SPDT (2-Speed), Limit Type: Temp Control, For Use With: CNT100-Series (MCCA) Variable Speed Drive Controllers and the TWR200-Series (Mini-Controller) Variable Speed Drive Controllers from Trane

A SPDT switch is made up of two pairs of opposing semiconductor devices (one n-channel, one p-channel), referred to as "MOSFETs", or simply "transistors

SPDT Temp Limit

The SPDT is housed in a metal enclosure with three mounting holes at one end

Protect your Trane (CNT1031) with the Pro-Guard SPDT Switch by Neuco

It features a 3/8" male pipe thread connection, which allows flexible placement in the system

The SPDT has three terminals, two of which are normally connected to the zone and one which is normally connected to the common terminal of the zone power supply

Trane SPDT Temperature Limit Switch is designed for installation on a Trane furnace

This switch is a safety device that can easily be installed for peace of mind

The Trane CNT1031 Temp Limit Switch is a device used in heating and cooling systems to monitor the temperature of a fluid or the air

It also prevents you from wasting energy and money

It is a good idea to replace the SPDT Temp Limit switch every few years

It is used in three-way applications and works by cutting off power to the defrost circuit when it reaches a predetermined temperature

120V SPDT Limit Switch with lever actuator

These devices are usually installed on the heating side of the system, however they are also used on the cooling side in applications where it is necessary to limit temperature maxima and/or actuate auxiliary equipment

This switch can be used for on-off or limit control of most directly fired Ducted Heat and Air units

If you have your old SPDT Temp Limit switch, you can replace it with this one

Also available in a single pole version, the CNT1030, which is the same but without the rocker switch for manual override

It comes in white color and has a temperature range from 25 to 70 degrees Fahrenheit

It is made of bronze and has a 1/4" x 20 thread size

The CNT1031 is a single pole changeover/single pole temperature limit switch

This SPDT Temperature Limit Switch comes with mounting hardware and instructions for use

The SPDT (single pole, double throw) features a Limit and an Auxiliary switch contact

SPDT Temp Limit Switch - CNT1031 - Trane

The SPDT Temp Limit Switch from Trane is a replacement for your furnace or air conditioning